goodwrench 4l80E quick help
- Thread starter bezerk
- Start date
Foot Performance
Donating Member
Re: goodwrench 4l80E quick help
I would say go for it that is pritty cheap for a new goodwrench trans usually like 2800 :tup:
I would say go for it that is pritty cheap for a new goodwrench trans usually like 2800 :tup:
![Quickstop [UK]](/forums/data/avatars/m/5/5165.jpg?1570199786){kind=avatar}
Quickstop [UK]
Combating adversyty.
Re: goodwrench 4l80E quick help
just make sure you order all the internals BEFORE this weekend- no need no cannibalising my truck ya hear :rotf:
just make sure you order all the internals BEFORE this weekend- no need no cannibalising my truck ya hear :rotf:
MRKING
New Parts for Old Trucks
Re: goodwrench 4l80E quick help
thats a little much but knowing everything would be good to go makes it worth it if you have the money . i wouldnt pick up both and your not gonna use the conv anyway . get the 2wd one swap the output shaft and short lever and slam it in .ya done yet ?
thats a little much but knowing everything would be good to go makes it worth it if you have the money . i wouldnt pick up both and your not gonna use the conv anyway . get the 2wd one swap the output shaft and short lever and slam it in .ya done yet ?
Quickstop [UK]
Combating adversyty.
Re: goodwrench 4l80E quick help
Maybe I should buy the second one in case?
Maybe I should buy the second one in case?
bezerk
New member
sparkwire
Donating Member
Re: goodwrench 4l80E quick help
If you had yhe 32 sline input shaft in your transfer case, get the 2 wd, pull the tailshaft housing, if it is splined all the way up, put on the tc adapter for the 80e,(RPM) put on the tc adaper, mark a straight line accross the shaft, and cut the output shaft off, you allready have the rear reluctor and sensor, change out the short shifter shaft, pick up a torque coverter and your good to go. my transmission is a 06 and it had the long slined shaft!! the 32 spline transfer case shaft is no longer available, GBlake item.
If you had yhe 32 sline input shaft in your transfer case, get the 2 wd, pull the tailshaft housing, if it is splined all the way up, put on the tc adapter for the 80e,(RPM) put on the tc adaper, mark a straight line accross the shaft, and cut the output shaft off, you allready have the rear reluctor and sensor, change out the short shifter shaft, pick up a torque coverter and your good to go. my transmission is a 06 and it had the long slined shaft!! the 32 spline transfer case shaft is no longer available, GBlake item.