Quick FP question
- Thread starter gjp
- Start date
ghettosled
SYTY SUPERSTORE
Re: Quick FP question
probably the pulsator in the fuel rank.. between the pickup and pump, it is supposed to dampen the noise.. not much to worry about as long as your pressure goes up with boost.
probably the pulsator in the fuel rank.. between the pickup and pump, it is supposed to dampen the noise.. not much to worry about as long as your pressure goes up with boost.
gjp
another post whore
Re: Quick FP question
pressure goes up when I give it gas. Not sure about when I boost but the wbo2 shows everything is good. I am just trying to track down a miss at idle. injectors and fpr are new and the fuel pump was replaced last summer by previous owner. Not sure if it was done right. Might pull the bed off and check. Truck starts up good and blows white smoke but not black so i dont think gass is leaking in through the injectors. thanks for the info.
pressure goes up when I give it gas. Not sure about when I boost but the wbo2 shows everything is good. I am just trying to track down a miss at idle. injectors and fpr are new and the fuel pump was replaced last summer by previous owner. Not sure if it was done right. Might pull the bed off and check. Truck starts up good and blows white smoke but not black so i dont think gass is leaking in through the injectors. thanks for the info.
![Quickstop [UK]](/forums/data/avatars/m/5/5165.jpg?1570199786){kind=avatar}
Quickstop [UK]
Combating adversyty.
Re: Quick FP question
this is a syclone thread isn't it.
this is a syclone thread isn't it.
Andreas
New member
Re: Quick FP question
Army, it is a PITA for Ty's.
Its SOOOO much easier with braided lines from the tank.
Here a link for Ty`s http://www.sytyarchives.com/howto/viewarticle.php?article_name=ty_fuel_pump.php&dir=engine
Army, it is a PITA for Ty's.
Its SOOOO much easier with braided lines from the tank.
Here a link for Ty`s http://www.sytyarchives.com/howto/viewarticle.php?article_name=ty_fuel_pump.php&dir=engine
Quickstop [UK]
Combating adversyty.
Re: Quick FP question
Andreas - thanks man. Those gaskets are ready to go - did you see the pics?
Mark
Andreas - thanks man. Those gaskets are ready to go - did you see the pics?
Mark
Quickstop [UK]
Combating adversyty.
Re: Quick FP question
I gave the templates to a guy in a jet engine workshop. He used AutoCAD 2000 and cut them out with a laser using aviation standard equipment (he works on the helicopter engines that I fly).
I am pretty pleased! He'll make more if anyone is interested. It ended up being .9mm, so I will put 3 in and see what happens. That is my project for the summer.....(one of many!)
I gave the templates to a guy in a jet engine workshop. He used AutoCAD 2000 and cut them out with a laser using aviation standard equipment (he works on the helicopter engines that I fly).
I am pretty pleased! He'll make more if anyone is interested. It ended up being .9mm, so I will put 3 in and see what happens. That is my project for the summer.....(one of many!)
