Part Numbers for Knock Sensor & Harness
- Thread starter Michael
- Start date
SeattleSy#1255
Category 5 Conservative
Re: Part Numbers for Knock Sensor & Harness
one option is to disconnect the original one, buy a new one, install it and run it to the ECM.
Michael said:
one option is to disconnect the original one, buy a new one, install it and run it to the ECM.
SeattleSy#1255
Category 5 Conservative
Re: Part Numbers for Knock Sensor & Harness
also, may check out sytyauthority.net under part #'s.
also, may check out sytyauthority.net under part #'s.
Re: Part Numbers for Knock Sensor & Harness
Thanks,
Michael
That's what I was hoping to do. Doesn't the knock sensor have its own dedicated harness to the ECM (separate from the main harness)? IIRC, that is how it is represented in the manual. I was hoping to buy that "knock sensor harness" as well as a replacement knock sensor, so I could just make the connection at the ECM (and leave the original sensor & harness in place except for the connection at the ECM). Will this work? Anybody know what the part numbers are?SeattleSy#1255 said:
Thanks,
Michael
bezerk
New member
Re: Part Numbers for Knock Sensor & Harness
make a switch between the excisiting setup and the new setup you are connecting, so you can read wich one gives you more knock or less, i did this and cut a connector off of an old truck, and soldered that onto the new wire i routed from the ECM to upfront
make a switch between the excisiting setup and the new setup you are connecting, so you can read wich one gives you more knock or less, i did this and cut a connector off of an old truck, and soldered that onto the new wire i routed from the ECM to upfront
Re: Part Numbers for Knock Sensor & Harness
In case anyone wants to go the same route, the GM part number for a "harness repair kit" for the knock sensor connector is 12102621. It includes the connector and a short length of wire (plus a shrink/crimp splice).
I am still getting some knock counts, even with a new IC pump and 100 octane gas. The counts only come on the shifts, so I suspect it is noise in the trans. I will try the front knock sensor location and see if it improves.
Thanks and regards,
Michael
In case anyone wants to go the same route, the GM part number for a "harness repair kit" for the knock sensor connector is 12102621. It includes the connector and a short length of wire (plus a shrink/crimp splice).
I am still getting some knock counts, even with a new IC pump and 100 octane gas. The counts only come on the shifts, so I suspect it is noise in the trans. I will try the front knock sensor location and see if it improves.
Thanks and regards,
Michael
Slow-Clone
Snow-Clone
Re: Part Numbers for Knock Sensor & Harness
Update?
Update?