Re: Vote to help me deside!
No, to elaberate on what J is telling you the 45mm front isn't a high enough offset, you need to get more of the wheel under the truck, not push it out with a spacer. Like I said before these wheels where designed with BMW's in mind. The 3 series is the only one that runs a high offset wheel, they don't run that wide of a wheel in the front, so your looking at wheels for the rear, they don't need a 50+ offset so it's going to be hard to find a perfect fit since they didn't have S series trucks in mind when they designed these wheels.
You don't need spacers with this setup. Picture this, you need to take those wheels and sand down the center area where it bolt up to the hub approx. 10mm ( or about a 1/2" ) on the front and about 30mm on the rear ( or about 1 1/4" ) see the problem. With those width wheels you don't need spacers you need them way way way under the truck, so they don't stick out.
Remember if was easy or cheap everyone would do it, keep searching :tup:
Oh and no you probably don't want to have those wheels machined down because they engineer them with a certain amount of structural integrity for that center thickness, you take that away and now have 3 piece wheels and not in a good way
