Recent content by bigK

Re: 92 Ty Blk/Blk #0053 Columbus, Ohio Thanks...and the truck sold last night. The intake is gray and then I clear coated it, same with the intercooler

Re: 92 Ty Blk/Blk #0053 Columbus, Ohio No...he was not a member, he found my ad on Autotrader.

Re: 92 Ty Blk/Blk #0053 Columbus, Ohio SOLD!!!!!!!!!!!!!....It just left an hour ago....I'm sad

Re: Just ordered my personalized license plate I went with BAD WTHR

Re: what you think I dig the OZ

Re: 92 Ty Blk/Blk #0053 Columbus, Ohio Yea...what he said:D

Re: 92 Ty Blk/Blk #0053 Columbus, Ohio Sounds good...let me know if you have anyquestions

Re: 92 Ty Blk/Blk #0053 Columbus, Ohio I've added some additional images....see link http://s101.photobucket.com/albums/m54/062572/?start=0

Re: 92 Ty Blk/Blk #0053 Columbus, Ohio Thanks - I did take it to the track when I first got it, it ran a 13.99. It hasn't been since all the updates.

Re: 92 Ty Blk/Blk #0053 Columbus, Ohio The long block is original/stock. I've run synthetic in it as long as I've had it and the previous owner told me he did the same. The trans is original too. Shifts firm, no problems.

This truck has been in storage and has not been driven since May 2007. I've been working on doing a few things to it over that time and I've just recently finished it. Here's what I've done in that time. All of the following parts have less than 70 miles on them: 57MM Waller Performance...

Re: No spark....help!!! IT'S ALIVE!!!!!!! I can't believe I over looked the problem several times. As I orginally stated in my first post, this truck has been in the garage for 2 years now. About a year ago as I was replacing many parts and among them I purchased replacement coil harness...

Re: No spark....help!!! First, thanks for all the replies. The tach does not move while cranking, but should it? Either way, I am not getting spark so it won't provide the necessary signal to activate the tach. Could someone please confirm thier tach is moving while cranking. I have already...

Re: No spark....help!!! The rotor is turning, we confirmed by turning it over with the cap off. We tested for spark a couple ways, screw driver in a plug wire, spark plug in the plug wire and no strobe from a timing light.

Re: No spark....help!!! New ECM and distributor, still no fire. I can't believe this!! What else is there? I'm thinking a gallon of gas and a match will take care of the fire problem.