Recent content by Divette

Hi. I recently buy on TY 92 1368. I was enraged with a sound which appeared посе closings TB. I have decided to establish bypass Bosch from Saab.

Re: What it is better ECM Today has noticed, that in "Р" pressing on a pedal, the temperature, very quickly, with 140 up to 210 for 5 seconds starts to grow. What would it mean?

Re: What it is better ECM On single turns the motor works exactly, does not shiver. That can occur on WOT, turns do not rise above 2500, on 50% WOT Turns rise up to 4500 and above, there are no problems.

Re: What it is better ECM All new, down pipe stock, no cat, Knock new, Wire MSD.

Re: What it is better ECM Ngk 7773 UR6 pump is work. I gave the turbine to repair, asked from to make a upgrade of a compressor wheel. I can that that to change in Prom, I have CATS? Not check engine Thanks

Re: What it is better ECM You are probably right, how it to learn? I have a scan tool Diacom. Thanks

Re: What it is better ECM At me the problem, 50% WOT works well, 100% WOT it is a lot of smoke, turns do not raise rpm, the motor is switched off. Who had such problem? Changed ECM (used) three times.

Hi. I am going to replace stoke Ecm, that will advise to put in replacements? Thanks

Re: Problem oil in Tb No oil. The passenger party 2 PCV valves are established In stock, I have one, you how many use?

Hi, I have found out a problem in the TY. Having passed 30ml after rebuild engine, at me the dark blue smoke began to go. I have removed TB and have found out there traces of oil. First has thought that it from PCv or turbines. Has disconnected them and start engine again, but oils has appeared...

Re: Problem with oil hose That is GMparts DVD, not legal

Re: Problem with oil hose you it is correct have said, it is necessary to use #15701719 [/URL][/IMG] Thanks sy1356

Re: Problem with oil hose think to buy these seal for 3$ [/URL][/IMG]

Re: Problem with oil hose OK. You offer to use #426 [/URL][/IMG] Or use A/C #7 from vette 01 [/URL][/IMG]

Hi guys. I have bought new oil hose, as on photo #12472311, but he differs from old that cost(stand)s on machine, no seal oil, this will be a problem when installing? Who had an experience, request to answer.