Recent content by ghettogmc91

Re: Garage clean out Pm sent

Re: Bunch of parts Are the head studs standard sbc or are for a v6? Looking for a set for a v8 build. Also are they used or still new?

Re: GP: traction bars Interested in a set if you decide on building more

Re: Built 700R4 and maybe transfer case Just wondering is that a brace from the transfer case to the transmission bell housing? I've never seen one before and just wondered

Re: Budget Paddle shifter idea http://youtu.be/NjNstTh2SVY Link to the write up http://ltxtech.com/forums/showthread.php?25757-Wireless-Paddle-Shifter-How-To&styleid=31

Re: Budget Paddle shifter idea Just an update for anyone interested this is finished and has a step by step write up

Re: Budget Paddle shifter idea I currently have the forced four because it hard wires the external controls. If this project works good I'm going to get the roadsurge for my 97 jimmy that way I can compare them and see if there's a difference. So far the only difference in them is the way to...

Re: Budget Paddle shifter idea From everything I've found the 4l60e uses the same design for the solenoids so the box will wire right up. Personally I'm doing it because I have a new transmission I've never used or seen used so it'll help me diagnose any issues it has since I'm swapping from...

Re: Budget Paddle shifter idea Btw I know the syty came with the 4L60 and this requires either a 4L60E or 4L80E but I know that quite a few people have swapped over to the newer electronic trans. Plus maybe this would be good for people wanting to swap without having issues controlling the trans.

I started this thread on the LTX forum and thought I'd post it here. http://ltxtech.com/forums/showthread.php?25631-Budget-Paddle-Shifter-idea Basically just looking for some input from everyone here to get some more ideas. I know there are a lot that do autoX and drag racing. Plus maybe if my...

Re: Tubular Transmission Crossmember Just ran across this. If there happens to be a spare 700r4 left over I have cash in hand for it. Doing a 4L60E swap this summer and would be a nice addition to it. If not I'll wait for the next round

Re: Wagon wheels... I've currently got the 17/18 staggered and have Nitto 555s on them all around. I runs spacers on the back just to make the rear stick out to match the front and personally I love them. I thought about running 18s up front but have yet to buy another set. If it helps any I...

Re: Syty vs blazer 4.3 Good to know! Guess ill just keep the tune in check and run it up maybe 10 or so. Definitely feel a lot safer with it now that I've gotten some first hand input on the setup!

Re: Syty vs blazer 4.3 Is that motor stock? This sounds about like what I was looking for. How much boost would you feel safe running without the alky kit? Just out of curiosity.

Re: Syty vs blazer 4.3 Thanks guys lot of info! As for the rebuild it's actually from my 91 jimmy. I rebuilt it then swapped to a built LT1 so it's a fresh 91 rebuild with the exception of .040 bore, edelbrock cam, and a ported vortec conversion. I'm hoping when this one fails it doesn't hurt...