Recent content by NoClone

Anybody have the part number for the ALDL wire harness? Or does that come with the ECM part # 16198263. I can't imagine it would. Anybody have any ideas on why the 'G' pin is missing and the wire behind it?

Oh, and I see what the guy meant by the ALDL being "damaged". The 'G' pin for the fuel pump isn't there. Nor is there a wire coming out of the back of the port. WTF! Am I in the right place? It's the little serial type port mounted under the dash on the drivers side just to the right of the...

Ok, today I tried the paper clip trick in the ALDL port. It did just like Daron said, the check engine light blinked for half a sec. then nothing. So I guess this means I'll need a new ECM. I found this part number off of http://www.sytyauthority.net/ (new GM #16198263) This is what I need...

Well I got there and the story changed to two hours to figure there was a "burnt" circut board in the ECM. The offical invoice says that the ECM would not communicate. I argued a little but I guess I wussed out and forked over the $136 bux for nothing much. Thanx Daron for the confidence...

I'm in Maryland in the Ellicott City area. Yeah, I'm gonna get it towed back to my house today but I'm gonna need to find someone with some experience with this. Daron you out there? Anybody? I also gotta tell this guy that it doesn't take two hours labor to "figure this out". They told me...

Ok, I turn the key over and the engine cranks over but I let go of the key the engine just dies. NGK UR5 Spark plugs? They look good. New Conrad Cap and Rotor? It looks good. Maybe it's the fuel filter or pump. So I take to the shop down the street, "for a professional opinion" :-? Now...

Daron Sweet! I have your email address. So I'll let you know when I have enough pennies for a new IC pump and heater hose. Probably in the next few pay checks. Later.

What's up! I live in the Ellicott City area. Right by Bob Galla I think. I'm a new Sy owner. email me if you wanna help me replace my IC lines in the next couple of months. Later tylerfisher@msn.com

Yeah, Yeah group purchase good! :D tylerfisher@msn.com

Count me in. My buddy couldn't live without his in his GN. tylerfisher@msn.com I guess I make 12?

I know what you're talking about I know what you're talking about I know what you're talking about! I think GMC made the arm rest low so to make it level with that corvette shifter. That's the first thing I noticed steping out of my bravada into my clone. The Bravada has the shifter at the...

Are there any good scan tools that don't require a laptop? Or is datamaster the best way to go as far features?

Right in front of the Safeway. Just wondering if it was one of you guys. I was in the Sy. Later.

I know it was a dumb question but you guys are F*#$ing awsome! Thanx

Yeah, that small line from the actuator should run to the Boost Control Solenoid, right? That's what diagram shows anyway. Thanx!