Recent content by Sloweracing

Re: Need a new or slightly used stock crank I have one from my sy 36000 miles what's it worth

Re: Billet TH400 Adapters Thank you.

Re: Billet TH400 Adapters Sounds great do you need me to send you a deposit.

Re: Billet TH400 Adapters I also got in on the group buy for the 32 spline input shaft so what ever works is good for me. I am cool with shortening the drive shaft and getting a new prop shaft made.

Has anyone tried the gen 2 pt6466 on their sy or ty. Just looking for some feedback on this turbo.

Re: Billet TH400 Adapters I am very interested in this adapter. Count me in just let me know who and where to send the money. My email is sloweracing@comcast.net.

Re: Setting timing question I checked TDC with a piston stop and it was dead on. That's why I was questioning timing chain. Gonna try a new timing light today to rule that out.

Re: Setting timing question My truck when idling at 750 rpm is retarded around 5 degrees. When you bring it up to around 1000 it jumps right to 0 degrees and then will go up another 4 or 5 degrees advanced as you rev it to 4000. Truck runs good set like this but if I set timing to 0 at low idle...

Re: Setting timing question Ok makes sense. By chance did you ever check timing with wire connected and reved up. Just wondering

Re: Setting timing question Good feed back on this thread. Just a question wouldn't you want the base timing set at the highest timing reading. So if you rev the motor and you get more advance at 3000rpm wouldn't you use that as your base other wise when you plug the brown wire in you will be 5...

Checking the timing on my syclone. My question is it normal for the timing to advance about 5 degrees when you rev the motor. I have it set at 0 at a idle but when you rev the motor it advances 5 degrees. Brown wire is disconnected. Truck does have a MSD ignition

Re: Fuel pressure drop That's kinda what I figured just didn't no if it was a common issue. Thanks for the reply

Is it common for a syclone to lose fuel pressure on a boosted lauch when you have just under a half tank of gas. It's fine when it's above half tank. I upgraded the fuel pump and also put in a new tank.

Re: New member from bucks county PA Going to mod the stock intake. I thought about doing the turbo upgrade first but I think a good built motor should be done first if your gonna want to lean on it. I can always step the turbo up.

Just touching base I purchased a 32000 miles syclone about 16 months ago #1670. I did some minor mods 3bar map sensor, adj fuel pressure reg, Hood tuned chip, RPM exhaust, and upgraded fuel pump. First time at the drag strip was really happy with a 12.80 timeslip. In the process of modifying...