Search results

This listing is for a G80 locking 8.5 inch differential with 3.42 gears RPO gu6. Drum to drum with parking brake cables and all for 300 bucks. I bought a 96 2door 4x4 Jimmy with a blown engine and a manual trans and am parting it out. I have the clear signed title. Just got the vehicle on...

Does anyone know what this harness goes to in my truck? I was thinking/hoping (reverse order) that it's for the trailer brake controller that I'm trying to install. I have the electrical service manual and I have no idea where in this 500 page tome it could be. It has never been in use to my...

Hey guys, I was watching my baby on the emissions dyno @ 15mph the rear started to jive around a bit and at 25 it was pretty stupid. I do have a vibration that seems to hit pretty hard at about 55ish and really get into it at around 70 tapering back down (not off) over 80. I'm thinking...

Hey guys! I have a question regarding map sensors. I have the stock N/A map sensor on my Jimmy. I have a supercharger that won't go over 11psi and I was hoping someone could steer me in the right direction regarding map sensors. I found this on ebay...

I have a 92 4x4 goodwrench rebuilt 700r4 transmission. Bought on craigslist out of oklahoma. Drove up there and realized it was not a 93 like I thought based on photos DOH! Anyhow I just pulled the shift shaft as mine was damaged and the pan and was wondering if this held value to any syty guys...

I've lost my notes I found a few weeks back noting the pin to send my simulated narrowband signal to the ecu from the wideband. Does anyone know? I also have the factory service manual but haven't tracked it down there either. (3 books and thousands of pages).

So I spent a few hours poring over what I need to get my master cylinder or most likely my proportioning valve to work properly with my brakes. I have the dual piston front brakes off of the 98+ 4x4 and the little 7 5/8 disk rear out of a similar vehicle. My parking brake is absolutely horrid...

I reading that the MTX-L wideband will literally replace my existing (I believe 1 wire) narrowband o2 with a heated wideband. The gauge will then send narrowband signals to the ecu. I have a few pieces of the puzzle to put together: 1: Does the OE o2 bung match the threads to the wideband? 2...

Hello everyone! Here is a link to her: https://plus.google.com/u/0/101704830626701409905/posts/iv9SvsCi1tB This photo was taken when I got home when the transmission went out. Lost 3/4 after having tons of clutch material in the fluid. Have 8lbs of boost @ 5100rpm with a wynjammer...