Recent content by Slyclone

Squid, I seen one on FB pop up in PA recently it was eight hundo. At one point I also was after one and it took me 4 years but I found a pretty good one for 200 in a original box. When I searched everything that was on the market and available was a typhoon bumper cover already painted. At the...

What's wrong with the other 2 where are they bad?

I have to do this to my truck, ASAP. I determined that I need to remove the steering box from the steering shaft, remove pitman from center link then completely remove the steering box from truck. I guess once it's all out it possible to remove the pitman from the box on a bench top. Seems to...

I ordered a set of the gasket/oring from local GMC dealer. Come in 2 pack I believe I still have one left. They are pinkish brown color.

Years ago I had my truck up on all 4 and was able to do the pan by jacking the engine. Of course I had removed the motor mounts. I ended up replacing the timing cover with a updated billet design, and a " more accurate" timing pointer. After getting the timing cover I realized the pan had to...

Yes it's just vented. I have the factory tube that would originally go to the front airbox still connected. It rests up by the remote oil filter location. I did not want to remove it and have a open port back there. Occasionally I see a little steam stuff puffing from the hose up front. PCV...

I appreciate the information on the needle flipping topic, I was more or less trying to pin point on WHY it triggered the needle to go over board and why I discovered the dip stick popped. I have a easy non invasive way to fix the needle. I just rotate the cluster until the needle goes back...

If you can't find parts you can try to source one from a AWD astro/safari van.

Noticed my dipstick popped and oil gauge flipped Happened after I started it and ran,turned off an started again shortly after. Any ideas? PCV is intact. Aftermarket intake. One plumbed into the intake, the other goes to throttle body. Driver side I have the original hose hooked up that goes...

Is there any way I can intercept the coolant signal wire to the dash gauge within the cabin of the truck? Specifically a place to look for the wire ? What I am trying to do is temporarily install a auto meter temp gauge I have laying around in a box, and see if it responds different in the...

I think ones steel. Ones aluminum.

Wow I'm surprised. When I sourced mine- when I had inaccurate readings on my gauge I pulled the part number from racetronix. That's where I got the Delphi number. It was 70 or 80 dollars through them, plus a bit of a wait for it to arrive. I think I landed mine for around 30.. hasn't been a...

I bought a Delphi brand one it seems ok. Had inaccurate reading on my gauge, replaced it. I don't have the part number on hand but I saved the box like a pack rat.

Being the parts are off a shared vehicle platform the ports I believe are coolant passages used on ZR1 Corvette platforms. DaveP is seemingly a expert with that topic and I don't want to cross too far into that territory. I believe there both capped on our vehicles.