Recent content by adrenalin rush

Some very compelling points here! Great information from Frank and the rest of the SYTY community. I am a fan of the MS3, its easy to use, powerful and cost effective. It's great that the Buick V6 is finally getting a PnP unit from MS3 but when will the SYTY get one? That would be the icing on...

Re: 2017 Mark Williams 4l80e to Borg Warner 4472 input shaft Sounds good! Thanks Sent from my iPhone using Tapatalk

Re: 2017 Mark Williams 4l80e to Borg Warner 4472 input shaft I came across this thread today about the input shafts for the BW transfer case so we can put a 4l80e in our syty's. I am getting my parts together to do the conversion. Are these input shafts still available or was this a one time...

Re: Can't start the Sy on code 59 Thanks for the quick reply Dave, I did offset correctly and I did get this fixed. I had to uninstall the Burn 2 software from Moates, my machine did a windows update and after that is when the problems started. I burned a BIN, then read the chip and it was not...

Re: Can't start the Sy on code 59 Thanks for the quick reply Dave, I did offset correctly and I did get this fixed. I had to uninstall the Burn 2 software from Moates, my machine did a windows update and after that is when the problems started. I burned a BIN, then read the chip and it was not...

Gents, I have been trying to get my truck running on code 59 but have had no luck. Here is the deal. On code 58 and a 2bar Map, the truck starts normal, runs and drives. I load the code 59 and swap in the 3bar and it starts but idle is high (2k) and the check engine light is on but won't show a...