Search results

Hoping someone may have a upper pendulum throttle bracket laying around

Anyone know the length difference between a SY vs TY driveshaft? Looking to swap my SY transfer case to a TY and there are differences in the output shaft length and diameter. Plus, anything else I should know before attempting the swap? If there’s an old post in the topic please point me in...

Has anyone thought to make or know where I can get one of the PAS Shreveport LA stickers with the alligator on it? You only really see them remaining on stock paint trucks.

Does anyone have a color match recommendation for our upper intake and Intercooler? It’s a bit elusive but I’m sure someone has it.

Looking for a 1320 Electronics or Red Devil 12 pin blue tooth adaptor. 1320 is out and Red Devil not responding to an issue with a unit I have. Chip shortage I'm assuming.

And maybe the 6AL setup

Looking for a good condition stock or superstock upper Intercooler

Looking to source a used engine or block for a fresh rebuild. GM #10205294. Mileage it not too important just need one that’s straight and un-bored. Let me know if anyone’s got a lead on one. Thanks

Looking for the complete steering wheel in any condition. Need the horn button cover.

I've searched through much of the archive and haven't has luck with my issue. The answer is probably so obvious that I'm just missing it because I've been cranking on my truck too long today. What's the easiest way to get the crossover off of the manifolds? I cannot for the life of me get a...

Here's something you don't see everyday. http://www.ebay.com/itm/1991-GMC-Syclone-Typhoon-6-Piece-Full-Bed-Cladding-Body-Kit-Set-New-Old-Stock-/291412968141?hash=item43d99102cd&vxp=mtr

Up for sale are a matching pair of front hubs for a sy. Not sure if they fit ty's but probably do. One is brand new and the other I mounted for probably 10 miles. Well made bearing, housing, and fit. The ABS toner ring on these are less than OEM in my opinion and this is why they're up for...

or you'll have the flang on your front differntial fall off! So I was replacing the drivers side have shaft and all was well until I pulled on the shaft to take it out and the differential flange came with it. Any thoughts on where to start to put that together? I'm getting the retaining ring...

Look for a pair of original SY floor mats.

Trying to figure out if my valve is bad. Does anyone know off the top of their head if the BB goes in first under the spring or the spring first, bb, then knob. Cant seem to get it dial in any longer.

Is it possible to have DM runs with ZERO spark retard? I'm getting a little knock count in 3rd at full boost but the KR line is totally flat. Either I'm a lucky son of gun or somethings not right. I don't hear any knock, truck pulls hard and steady, and spins from 1-2. Gotta be something...

I'm trying to hunt down a good (as good as they could be 20+ yrs old) set of orginal vacuum hard tubing for the factory boost solenoid and wastgate. Elbows and all. Surely someone one this board has a set laying around.

Anyone know the best way to splice in an AF gauge into the ECM or at the O2 sensor?

Looking for a stcok IC.

I installed a Stage1 54mm turbo and am unsing a new factory actuator. I set the actuator with the proper preload. The problem is a major boost spike up to 25lbs and it falls back and stays at 10lbs. If you let off for a split sec and throttle up it will do it again. I adjusted the actuator...