Search results

Re: New Alaska Owner - Sy #2227 Wow Pete is parting with his Hmmmmmm ... I know he did a few things to it ,, So whos Sy is the 12 sec one ???? Any prices ??

Re: New Alaska Owner - Sy #2227 Im staring to have Sy Ty withdrawls now LOL...... I wish I still had my Ty ... Hey Tim let me know is theres another one avaliable !!!

Re: Green POS Ty spotted I went out to Wasilla with TIMBO to check that TY out ,,, Its pretty clean up close ,, looks real nice !!!

Re: No start; give me some troubleshooting ideas. Now get that bad ass on the road !!!!!!!

Re: Question about rear wheel/axle placement I contacted JTR and ordered a pair of 2 inch lowereing blocks and set back plates ,, when I installed it the axle centered just about perfect ,, the blocks and plates are real beefy along with the U bolts .. Jon

Re: No start; give me some troubleshooting ideas. Go ahead and pull the linkage at the throttle body ,, its not too hard to hold the test probe while doing it ,, And does the computer use a cam sensor or crank sensor ,, If the computer in my GN doesnt see the engine rotating it wont turn on...

Re: No start; give me some troubleshooting ideas. Hey Tim ,, I use a small paperclip and straighten out the last wrap so you have a little probe about 1 inch long ,, then probe the middle wire and connect test lead from the fluke meter then ground the other lead .. you can carefully slide the...

Re: Idle way too high at running temp Well after checking everything I could think of for vacume leaks I decided to reset the IAC as per instructions found on the forum ,, funny thing is it will idle right back where its supposed to until you start to drive it ,, then it imediately goes back to...

Re: Idle way too high at running temp Man thanks for the replys ,, I have been searching around the intake tract just now ,, I removed the IC and the TB ,, everything looked OK,so I started looking at the vacume lines ,, so far I found 4 connections leaking and a small hole in the tube...

Hey guys ,,, I just tuned up the Ty this week ,, I had an idle problem where it would idle at 1500 rpm and then vary all over the place ,, I got a new IAC and the idle is where its supposed to be when cold ,, after warming up to running temp the idle goes to 2200 RPM and wont come down ,, check...

Re: brake boost problem I gave the neutral rev a shot today and it works good , now I can hold about 3 to 5 psi ,,, comes out of the hole like mad now LOL.... Thanks for all the tip's .. Jon

Hey guys ,,, So I'm playing around with the Ty ,, and I find a street with no traffic so I stop and try a boost launch ,, When I start to build boost the brakes wont hold at all , the boost guage is not even building any boost yet , I'm still reading in the range of vacum on the stock boost...

Re: Handling issues I had plans to go through everything on this baby , Its definitely worth spending the money .. I've seen a few threads on aftermarket tubular control arms and coil over conversions , I know its probably big bucks but do they improve the handling (tighter more controlled)...

Re: Handling issues You know I kind of figured that ,, My buick pulls real bad but thats because its airbagged and if you dont get that ride height set just right it will handle like crap untill you tweak it a little ... Thankd imbo ,, check you PM's Jon

Hello everyone , I'm new here , I'm normally a turbo buick guy and I'm looking at buying a 92 typhoon , Very clean ,never been wrecked , awsome paint(white on white) about 80,000 miles , Nice leather interior , motor runs awsome ..... I'm picking it up for around $11,000 , I'm ready to buy...