Search results

WTS - new unused RPM Typhoon Torsion Bar Delete , was purchased back in 2009 and never used, unfortunately sold my Typhoon and cleaning out the garage forgot I had it. Location is Calgary, Alberta, Canada Asking - $450 CAN ($330 USD)...

Re: Leaking Injector & IC Pump issues I've spoken with Aaron and we've set the exchange in motion, so here's hoping to have a set show up in the next couple weeks. I will be redoing the intake gaskets after pulling the plenum off and having the gasket near disintegrate in the process it only...

Re: Leaking Injector & IC Pump issues Well I couldn't sit still any longer haha :rotf:, between waiting to hear back from Sportmachines about the defunct pump and the uncertainty of the injector I dug into it and got it apart, and I found #2 injector missing 1/3 of the pintle cap. The o rings...

Re: Leaking Injector & IC Pump issues Well I had some time to try and diagnose a few problems, under hood light seemed to just be a ground as a few you pointed out. I checked the fuse behind the alternator and sure enough it was blown, put a new one in it blew as well. So I started looking for...

Re: Leaking Injector & IC Pump issues Truck has been stored inside for 4 of the 5 years. I'll have to pull the intake plenum to get at the injectors to check for sure, but it doesn't sound like a bad o ring more along the lines of what Don W mentioned as the injector itself is buggered. Reason...

Re: Leaking Injector & IC Pump issues Didn't even think about a position sensor for the hood being open, ill have to take a look at that. As far the pump goes, I cut the connector off the old pump and soldered it onto the Johnson pump leads so it would plug back into the factory connector, I...

Back again with a few more issues after you guys helped me sort out my turbo coolant lines. Finally got the truck up and running after a long 5 years sitting so I assumed it was gonna have a few more problems. Figured Id just make a single thread rather then clutter up the forum. Anyway my...

Re: Turbo coolant line Help Wow you guys were quick, much appreciated. Yea I'm fairly confident its buggered, i can get it to start threading but its clearly going in on an angle, and I spent the better part of 2 hours trying every which way. Ill confirm that when I get the fitting out of the...

I recently picked up both the coolant and oil lines for the stock turbo from RPM and managed to get both the upper Coolant line and oil drain line on without a snag. Started working on the lower coolant line and after pulling the starter I managed to get the old line off, In the process i must...

Hello fellow Canadian SYTY owners, I've recently pulled my typhoon out of storage after a long wait and looking to get some things done too it. One of which is looking for a new set of Wheels. I'm interested in finding any of the following if anyone has a set of Corvette C4 ZR1, C5 Z06, C6 Z06...

Well I figured now's as good a time as ever, Ive been a straggler on the forum for a while now and just wanted to thank all of the enthusiasts here at SyTy.net for the great wealth of knowledge and information, It has gotten me out of a few binds. :tup: I've had my typhoon for some time now...

Re: Silicone Vac Kits GP Interest - read! I'd be interested in a full stock kit.