9 bladed 60-1 bolt on Turbo.

It's just a six

It's just a six

Super Member
Re: 9 bladed 60-1 bolt on Turbo.

I thought you were going to use this one?
What happened?

Or you want the same but w/a 12 CM housing?

Bump for the sale Good luck!
 
Darin

Darin

New member
Re: 9 bladed 60-1 bolt on Turbo.

No, I have another billet 25G with a 9 blade with the divorced 12cm housing. I'm keeping that one :)
 
Darin

Darin

New member
Re: 9 bladed 60-1 bolt on Turbo.

The divorced wastegate housing isn't a bolt on to the stock downpipe. You'll need to either make one or modify the stock pipe. It's a different flange.

I would think this would work very well on a 2600 stall converter. I do have a billet wastegate, but the forge unit is without a doubt superior, albeit more than twice the money. It doesn't mount the same as the stock unit, so you'll have to contact forge on which to purchase.
 
Darin

Darin

New member
Re: 9 bladed 60-1 bolt on Turbo.

I forgot to mention that this turbo comes with a new T3/Manifold gasket, new oil drain gasket, and a new oil inlet/copper crush washer fitting.
 
Syclone #1188

Syclone #1188

New member
Re: 9 bladed 60-1 bolt on Turbo.

This is almost what Im looking for. Only thing is, Im not sure how the 14cm turbine housing would work with a stock torque converter.

Will a smaller 10 or 12cm turbine housing work with this, without modifications?
 
Last edited:
Darin

Darin

New member
Re: 9 bladed 60-1 bolt on Turbo.

It's pending sale right now. If it comes available I'll let everyone know.

According to 0996sy, with a forge gate this should be fine with a stock converter, I can't comment though.

You can buy a 10cm housing that will help spool it much quicker if needed.
 
It's just a six

It's just a six

Super Member
Re: 9 bladed 60-1 bolt on Turbo.

Syclone #1188 said:
This is almost what Im looking for. Only thing is, Im not sure how the 14cm turbine housing would work with a stock torque converter.

Will a smaller 10 or 12cm turbine housing work with this, without modifications?
Click to expand...

AFAIK, The factory 10 & 12 CM turbine housings are not machined for the larger TD06H turbine wheels.

If you get a 10 or 12 CM housings, you would need to machine the turbine housing to fit the larger TD06H turbine wheel.
 
Last edited:
Darin

Darin

New member
Re: 9 bladed 60-1 bolt on Turbo.

There is a 10cm available in TD06H that's a direct bolt on. I can't find a direct bolt on 12, however.
 
atkonkler

atkonkler

Is this your bush?
Re: 9 bladed 60-1 bolt on Turbo.

In the pic in the link I'd say it's a 8cm...but then again they use generic pictures for products that look similar
 
Darin

Darin

New member
Re: 9 bladed 60-1 bolt on Turbo.

Is this the post to be arguing this?

The 10cm housing is also available direct on the kinugawa site, look it up.
 
You must log in or register to reply here.
Top