ANS Performance boost controler Q's

[SpoolingTurbo6]

Dose anyone know anything about these or have one?

It seems to work fine But unsure if the ECM can still control boost

When in ECM mode,when in t/c (turbo control) mode the factory

solenoid clicks open/shut fast or slow depending on knob setting

to the right is slower to the left faster unable to upload pics

|----------------|
| ANS Perfor. |
| |
| {}- |switch
| tc |
| |
| {}- | switch
| ECM |
| |
| BOOST |
knob
() <------
______________ Thank you all for looking at this

[/url]

 

[leroy]

I used to have one and it worked fine. There's always the temptation to turn up the boost farther than you should when you have a boost controller, though. You are still limited by the stock wastegate and wastegate solenoid, so I'm not too sure how it would work if you had an open or free-flowing exhaust.

Jim

 

[SpoolingTurbo6]

stock turbo & wastgate are gone

stock turbo & wastgate are gone

I've installed the Te 60 (ar-60-1) And very free flowing exhaust

The stock wastegate gets pluged into this ANS controler

I wonder if it still opens under ecm comand when in ECM mode?

Of couse noone at ans can help!!!!

 

[leroy]

The ecm still controls the boost in ecm mode if it was installed correctly.

You're not really using the stock wastegate are you? I think you meant wastegate solenoid. ? Anyway, the ANS should work pretty good if your wastegate is sized appropriately.

Jim

 

[SpoolingTurbo6]

correctamoondo

correctamoondo

Yeh I better fix that

PT&E 60 with there wastegate

Leroy...do you have much experience with these

 

[leroy]

Re: correctamoondo

Re: correctamoondo

Yeh I better fix that
Leroy...do you have much experience with these

Like I said, I used to have one, and it worked fine. I sold it because I got into controlling the boost with the chip. In ecm mode, the chip takes over boost control. Otherwise the controller produces a duty cycle to control the wastegate. It can even be used to lower the boost, IIRC.

Jim