Dimensions from intakemanifold

B

Breth

New member
I will built my own custom intakemanifold. I will directly screw it on the stock bottom manifold who is screw it to the heads...
So i need the dimensions of the bottom-plate from the upper intake-manifold.

BTW: is there a gasket between the upper and the lower intake manifold??

Best regards Breth
 
M

MikeRenz

not stock
Re: Dimensions from intakemanifold

if you're going to build your own, then you're best off building it on the lower intake manifold.

Or, if you want, i can sell you a flange that would make your life a lot easier:
Flanges.jpg


What kind of intake are you planning on making? If you want to make a front facing one, you could just buy one of mine:

IMG_0353.JPG
 
ghettosled

ghettosled

SYTY SUPERSTORE
Re: Dimensions from intakemanifold

if you are looking to build a sheetmetal intake manifold (not just a plenum), i have some older hogan style intakes that were setup for a carb. You could basically just build a hat with the TB opening. The intake runners, base plate, head flanges, water neck, etc is already there and tig welded.

kinda like this with a carb bolted to the top plate and no throttle body mounted yet.

18degsheetmetal2.jpg


I would take $450 for ea. and i have two. They've been sitting for awhile, but with some scotch brite you could shine them up like new. I can email pics if you are interested, Just email me at mike@raceprovenmotors.com

if you are looking for a plenum, then Renz' stuff would be a great start!
 
ghettosled

ghettosled

SYTY SUPERSTORE
Re: Dimensions from intakemanifold

will send pics. FYI, i said hogan "style" not actual Hogan intakes. Dunno who made them. Not Wilson Manifolds quality, but not a hack job either.
 
You must log in or register to reply here.
Top