TX FS:RPM solid mount set V6
- Thread starter 0966Sy
- Start date
0966Sy
Code what?
GarnetTy1473
Donating Member
Re: FS:RPM solid mount set V6
I should still have an extra set of the Moroso mounts. Need to dig them out of my garage. Brand new, still in package. I used them with JSM pads. Thought I lost the Moroso mounts, so bought another set, then found the original ones I bought.
berzerker
wookie
GarnetTy1473
Donating Member
Re: FS:RPM solid mount set V6
I used part # 62515 with JSM pads. Don't know what the difference is between the 62500 and 62515, but if someone could figure it out.
I used part # 62515 with JSM pads. Don't know what the difference is between the 62500 and 62515, but if someone could figure it out.
sytyguy
Moderated User
Re: FS:RPM solid mount set V6
The 62515 is a thinner (-0.062"), taller (7/8") and slightly narrower (1/8") mount than the 62500. Were they really tight to get on the frame pads JJ? Does your engine sit up any higher now (alt to upper hose clearance, fuel line length, fan to shroud clearance, hood to upper IC clearance, etc...)?
FWIW, the 62500 is 1-11/16" from base to pad hole (A), 2-1/2" wide pad mount (B), and .250" thick. The 62515 is 2-9/32" from base to pad hole (A), 2-3/8" wide pad mount (B), and .188" thick.
The 62515 is a thinner (-0.062"), taller (7/8") and slightly narrower (1/8") mount than the 62500. Were they really tight to get on the frame pads JJ? Does your engine sit up any higher now (alt to upper hose clearance, fuel line length, fan to shroud clearance, hood to upper IC clearance, etc...)?
FWIW, the 62500 is 1-11/16" from base to pad hole (A), 2-1/2" wide pad mount (B), and .250" thick. The 62515 is 2-9/32" from base to pad hole (A), 2-3/8" wide pad mount (B), and .188" thick.
GarnetTy1473
Donating Member
Re: FS:RPM solid mount set V6
That would explain why the transmission is as close as it is to the body. And I mean really close. I would like it to sit lower. Guess I'll be switching these out then.
Come on now, you know my truck isn't anywhere close to being that far done.
That would explain why the transmission is as close as it is to the body. And I mean really close. I would like it to sit lower. Guess I'll be switching these out then.
sytyguy
Moderated User
Re: FS:RPM solid mount set V6
You mean your truck isn't running?
The 62500 is the correct mount and if you want to raise the drivetrain slightly, you can run the blocks shims (62535).
You mean your truck isn't running?
The 62500 is the correct mount and if you want to raise the drivetrain slightly, you can run the blocks shims (62535).