help with torque settings

[gjp]

After I moved I lost my info on torque settings for the 4.3 engines

If anyone can look up the TQ for the:

oil pump bolt

oil pan

cam gear bolts (3)


Thanks
Also the old oil pump shaft was stuck on the pump. the arp one just sits on the pump???

 

[EcSy#2671]

Re: help with torque settings

I have them at home I will post them later.

with arp oil pump staft just push it on to the pump and turn it over it should stay in the block on top of the oil pump it did on mine.

 

[EcSy#2671]

Re: help with torque settings

oil pump bolt (stock): 65 ft. Ibs - 90 Nm

oil pan (stock): Bolts 100 In Ibs. - 11 Nm
Nuts at corners: 17 ft. Lbs. - 23 Nm

cam gear bolt: 21 Ft Lbs - 28 Nm

hope it helps

 

[gjp]

Re: help with torque settings

Thanks for taking the time to look that up for me. 65lbs for the oil huh..no wonder it was on there so tight.

 

[gjp]

Re: help with torque settings

cant find torque for dampner bolts. Also do I tighten the main dampner bolt till it bottoms out??

 

[EcSy#2671]

Re: help with torque settings

cant find torque for dampner bolts. Also do I tighten the main dampner bolt till it bottoms out??

There are torque setting for them, again I will get them when I get home. The main you can, but be careful I broke my bolt in the crank. :rant: Got lucky, it clean up fine.

 

[gjp]

Re: help with torque settings

Thanks. My book does not show them. I gues I can use the old "Good-n-tight" method with some locktight in there but I did not spend 80$ on a new tq wrench and not use it