Inj rebuild

[Don W.]

Just wondering who you folks have used, with success, to rebuild your injs?

TIA

 

[Sy+Ty]

Re: Inj rebuild

If you're talking about 'cleaned & flowed,' I sent my last set of Lucas injectors to Mike Lee at RPM. I was lucky & got in when he was doing his 1/2-off special, shortly after getting his new injector flow bench.

Sy+Ty

 

[2cold]

Re: Inj rebuild

Hey Don, you might want to try Santa Rosa Diesel, they can clean, flow, and rebuild injectors, had a few sets of Ford 2.3t low z injectors done there. Tell them Brett from Classic sent you, it'll probably cost around $100 same day turnaround

 

[Don W.]

Re: Inj rebuild

Called them once and someone said no. Hmmm, They're very close to where I work so I'll just swing by.

Thanks.

 

[SY2455]

Re: Inj rebuild

Don, Here is the place that I was told to go to by a old time guy that use the name of techweasel. He, I think had a different name here on Sy/Ty.
http://www.rceng.com/

 

[sbwrench]

Re: Inj rebuild

Don,
X 2 on RC engineering. We do some race bike stuff with him and I've done several of my personal cars. They do good work.
Al

 

[CKEITH]

Re: Inj rebuild

Just wondering who you folks have used, with success, to rebuild your injs?

TIA

why not send them to rpm.... not only is he a vendor but a damn good one at that. our vendors have brought us many innovations.....we should support them. :2cents:

 

[SY2455]

Re: Inj rebuild

why not send them to rpm.... not only is he a vendor but a damn good one at that. our vendors have brought us many innovations.....we should support them. :2cents:

:tup: x2, I should add that the link was given to me before Mike at RPM was set up to do the injectors. Now that he does them, I would most likely use him.

 

[Don W.]

Re: Inj rebuild

Correct idea. Was actually leaning toward RPM. I emailed and got cost from them already.

 

[2cold]

Re: Inj rebuild

Huh, don't know why they'd tell you that. I know for a fact that they do a good job of cleaning and flowing them. They will also give you all the before and after flow data. You should ask for Francis, he is the owner, they have good techs there, I wonder whats up with that.

 

[SY2455]

Re: Inj rebuild

Huh, don't know why they'd tell you that.

:dunno: I just know I was given the link many years ago and I know they do excellence work. But now Mike at RPM is set up to do them and he is a vendor that is here for us and, well you know the saying if you don't use your vendors, you just may wake up one day and they won't be there.