Jamie’s Syclone build

JamieL

JamieL

Member
So excited that the website is back in business. Not a big fan of Fb. The build is a fully built stock block and crank. Eagle rods, diamond pistons, Vortec heads, 6266 turbo, coil on plug, terminator X, 4L80e, bully front diff, 8.5 rear diff, carmaro rear brakes, C5 fronts. I’ll add more as I go.
 
SVO

SVO

GMC Racing
Ditto........
looks like your going to have some fun
hopefully pictures here and there 🤙
 
JamieL

JamieL

Member
The truck ran 13.60 with this mostly bone stock setup. It had a 2 bar pit bull chip with the fuel pressure set at 11.50 afr at wot. SPM lwr intercooler and a 255 pump.
 
JamieL

JamieL

Member
1524E3E5-05A6-4D5E-AFFD-D2FDCA6673D5.jpeg
Pulled the computer and almost have the wiring disconnected from the firewall. Also found some past wiring sins. The security system is getting deleted.
 
JamieL

JamieL

Member
Working on sorting out the factory wiring harness with the Holley terminator X. Any advise I’m open to suggestions. 8B0A8B24-28A6-4E77-886E-A50B9F2AAA42.jpeg
 
syclone0517

syclone0517

Member
JamieL said:
Working on sorting out the factory wiring harness with the Holley terminator X. Any advise I’m open to suggestions.
Click to expand...
Looking good so far. I'am currently in the middle of Typhoon resto-mod with a similar engine build less coil on plug and trans application. I envision installing holley ecu under passenger seat and splicing into factory harness at ecm connections with the exception of power,ground and a few add on's ie wideband o2 ect.. Best of luck with your build👍
 
You must log in or register to reply here.
Top