Need pics of a 2 bar sensor.

[NoClone]

Does anybody have a picture of a wastegate properly hooked up to the 2 bar sensor?

When I got the Sy back from the shop the small hose on the top of the wastegate is cut short. Does it clamp to the right side of the sensor, when standing in front of the car?

tylerfisher@msn.com

 

[Ian Turgeon]

If your talking about the vac lines on the turbo, they connect to the boost control selidiod not the map sensor. The map sensor is above the drivers side valve cover.

Well, on the turbo, the pass side of the selinoid connects to the compressor housing. The driver's side connects to the wastegate.

 

[Blake]

Wastegate doesn't go to the sensor. You should have a vacuum hose diagram under your hood on the radiator support I think. MAP and FPR share a vacuum source off the back of the upper intake manifold.

Tried to put up a pic but it didn't work.
Here's a link:
http://georgiasyty.com/turbonumbers.htm

Just follow the diagram.
Blake


<font size=-1>[ This Message was edited by: Blake on 2002-02-05 11:20 ]</font>

 

[NoClone]

Ok, I messed that all up. I should have did some more reading. I'm talking about the small vacum line coming from the top of the actuator. It's just dangling right now. It should be connected to the sensor right above it going to the turbo, right?

 

[NoClone]

Yeah, that small line from the actuator should run to the Boost Control Solenoid, right? That's what diagram shows anyway. Thanx!

 

[Ian Turgeon]

The driver's side connects to the wastegate.

yah.

 

[JoeLutz]

I know the quality sux. Tooky has a good pic, so ask him if you need a beter one.

_________________
Lenoir, NC

<font size=-1>[ This Message was edited by: JoeLutz on 2002-02-05 17:55 ]</font>

 

[Tooky]

I'm glad I took this pic because I am sure getting a lot of use out of it!

 

[NoClone]

I know it was a dumb question but you guys are F*#$ing awsome!

Thanx