Injected1
Member
I am selling off everyhting as a package deal, need the money very badly!
Box 1:
1) Lower radiator hose.
2) Collapsible spring hose.
3) EGR Solenoid
4) Pulley
5) Exhaust Clamps
6) Turbo coolant lines (feed & return)
7) Radiator overflow
8) Lower parking light
9) Turbo oil feed line
10) Motor mounts
11) Misc. heat shields
12) Steering shaft
13) Waste gate
14) Alternator
15) Accessory pulley
16) Accessory brackets
17) Thermostat gasket
18) Stock Syclone drive shaft
19) Stock Typhoon drive shaft
20) Front fan
21) Water pump
22) 2 Stock prop shafts
23) Misc. vacuum lines
Box 2;
1) Oil Dipstick w/ tube
2) Braided turbo feed line
3) Gas tank filler neck
4) Power steering pump w/ hoses
5) Battery hold down
6) 2 bar map sensor
7) Washer fluid res.
8) Fuse panel cover
9) Alternator
10) Injector Harness
11) Boost Solenoid
12) New fuel filter
13) Door vent
14) Idler Pulley
15) Ignition coil
16) Gas cap
17) Injector
18) Misc. vacuum lines & brackets
Box 3;
1 & 2) Distributors
3) Steering shaft
4,5,&6) OH-SHIT handles
7) Cladding piece for behind the drivers door
8 & 9) Fuel rails (with 4 injectors)
10) Gauge cluster harness
11) Misc. plastic hooks, push caps, covers & all interior screws
12) Air/Heat controls
13) Head & tail light controls
14) Cruise control
15) Alternator bracket
16) Throttle body
17) Metal turbo line
18) Upper intake
19) Braided turbo line
20 & 21) A/C compressors w/ brackets
22) Waste gate
23) Idler pulley & EGR valve
Box 4;
1) Typhoon wiring harness
2) Remote oil filter lines
3) Oil dipstick
4) Metal turbo coolant line
5) TV cable
6) Coolant return line
7) Cruise control
8) Alternator brackett
9) Lower intake w/ 6 injectors
10) Power sterring pump w/ line
11) Power steering pulley
12) Injector harness
13) Boost solenoid
Package 5;
1 & 2) Stock turbos
3) 20 G turbo
4) Power steering cooler
5) EGR
6 & 7) ECM's
8 & 9) Head gaskets (still in package)
10) Throttle body w/ push rods & misc gaskets
11) 6 Lunati rods
12) Upper inter cooler
13) 2 governors w/ calibration kit
14) Remote oil filter w/ lines
15) Red silicone vacuum line kit
16) EGR valve
17) Kenny Bell "Boost-A-Pump"
18) 4 bolt main Syclone block
19) 6 Injectors
20) Hood rod prop
21) 4 sets of spark plug wires (ATR, Autolite, MSD, & stock)
22) Sy/Ty part manual
23) Sy/Ty folder w/$20K & reciepts (not including $3600 Typhoon & $5500 Syclone)
Package 6;
1) 2 Corner lights
2) Flex plate
3 & 4) Crossover tubes w/ air boxes
5 & 6) TC inspection plates
7) Distributor cap
8) Stock FPR
9) Pulley
10) Inter cooler cover
11) Misc upper motor brackets
12) Washer fluid res.
13) Map pocket & arm rest for Typhoon
14) Typhoon over head console
15) PAS orange elbow
16) Throttle cable
Here are the trucks and their parts
Typhoon rolling chassis - no interior w/ black wheels
Stock Sy long block and heads (sludge in motor & a bent valve)
Stock Ty Transmission w/ no governor
60K mile motor w/ 20 G turbo and silicone vacuum kit, poly motor mounts, EGR delete, PTE 3000s
Syclone possibly built transmission w/ transfer case
Syclone full rolling red chassis w/ rear disc brakes, new front clip and new grille, complete interior, and comes with 60% cladding.
BUILT MOTOR
SHORTBLOCK
Stock block bored .030 over- $300
TRw L2441 pistons with JE rings-- $450+$125
Upgraded rods- $180
Clevite bearings- $40
Comp 415 Cam--$260
ARP bolts- $30+$65
Lunati lifters-$215
Chromoly pushrods-$100
Edelbrock TC-$70
SFI billet harm. balancer-$225
SFI race flexplate- $95
HV oil pump-$115
I have $2500 in parts alone not including labor
LONGBLOCK
Vortec heads-$125,
Drilled-$150,
5 angle valve job/teflon seats/bronze guides-$225
ARP 3/8 rocker screw in studs-$70
Comp cam 1.6 Rocker-$260
Comp beehive springs-$250
Cometic Head Gaskets-$180
Ferra valves-$70
Lower intake modded for Vortecs-$400
ARP head bolts-$150
Various machine work-$475
I have $4855 in the longblock not including labor. Basically the same as:http://www.sytyperformance.com/inde...facturer_id=0&option=com_virtuemart&Itemid=26
I will take $2000 for the short----$4000 for the long OBO
I can probably ship this in the 48 for less than $150
This combo is easily capable of low-mid 10's w/74gtq and proper tune
ATR headers, ATR down pipe, and Sy/Ty 700R4 Race transmission, let me know i have a price in mind to go with the package deal.
IF ANYONE IS INTERESTED PLEASE CALL ME!
Thanks, Nick
850 642 7433
All parts are located in Destin, Fl.
Box 1:
1) Lower radiator hose.
2) Collapsible spring hose.
3) EGR Solenoid
4) Pulley
5) Exhaust Clamps
6) Turbo coolant lines (feed & return)
7) Radiator overflow
8) Lower parking light
9) Turbo oil feed line
10) Motor mounts
11) Misc. heat shields
12) Steering shaft
13) Waste gate
14) Alternator
15) Accessory pulley
16) Accessory brackets
17) Thermostat gasket
18) Stock Syclone drive shaft
19) Stock Typhoon drive shaft
20) Front fan
21) Water pump
22) 2 Stock prop shafts
23) Misc. vacuum lines
Box 2;
1) Oil Dipstick w/ tube
2) Braided turbo feed line
3) Gas tank filler neck
4) Power steering pump w/ hoses
5) Battery hold down
6) 2 bar map sensor
7) Washer fluid res.
8) Fuse panel cover
9) Alternator
10) Injector Harness
11) Boost Solenoid
12) New fuel filter
13) Door vent
14) Idler Pulley
15) Ignition coil
16) Gas cap
17) Injector
18) Misc. vacuum lines & brackets
Box 3;
1 & 2) Distributors
3) Steering shaft
4,5,&6) OH-SHIT handles
7) Cladding piece for behind the drivers door
8 & 9) Fuel rails (with 4 injectors)
10) Gauge cluster harness
11) Misc. plastic hooks, push caps, covers & all interior screws
12) Air/Heat controls
13) Head & tail light controls
14) Cruise control
15) Alternator bracket
16) Throttle body
17) Metal turbo line
18) Upper intake
19) Braided turbo line
20 & 21) A/C compressors w/ brackets
22) Waste gate
23) Idler pulley & EGR valve
Box 4;
1) Typhoon wiring harness
2) Remote oil filter lines
3) Oil dipstick
4) Metal turbo coolant line
5) TV cable
6) Coolant return line
7) Cruise control
8) Alternator brackett
9) Lower intake w/ 6 injectors
10) Power sterring pump w/ line
11) Power steering pulley
12) Injector harness
13) Boost solenoid
Package 5;
1 & 2) Stock turbos
3) 20 G turbo
4) Power steering cooler
5) EGR
6 & 7) ECM's
8 & 9) Head gaskets (still in package)
10) Throttle body w/ push rods & misc gaskets
11) 6 Lunati rods
12) Upper inter cooler
13) 2 governors w/ calibration kit
14) Remote oil filter w/ lines
15) Red silicone vacuum line kit
16) EGR valve
17) Kenny Bell "Boost-A-Pump"
18) 4 bolt main Syclone block
19) 6 Injectors
20) Hood rod prop
21) 4 sets of spark plug wires (ATR, Autolite, MSD, & stock)
22) Sy/Ty part manual
23) Sy/Ty folder w/$20K & reciepts (not including $3600 Typhoon & $5500 Syclone)
Package 6;
1) 2 Corner lights
2) Flex plate
3 & 4) Crossover tubes w/ air boxes
5 & 6) TC inspection plates
7) Distributor cap
8) Stock FPR
9) Pulley
10) Inter cooler cover
11) Misc upper motor brackets
12) Washer fluid res.
13) Map pocket & arm rest for Typhoon
14) Typhoon over head console
15) PAS orange elbow
16) Throttle cable
Here are the trucks and their parts
Injected1 said:Syclone pics before and after:
Typhoon pics in primer:
Let me know what you think.
Thanks, Nick
Typhoon rolling chassis - no interior w/ black wheels
Stock Sy long block and heads (sludge in motor & a bent valve)
Stock Ty Transmission w/ no governor
60K mile motor w/ 20 G turbo and silicone vacuum kit, poly motor mounts, EGR delete, PTE 3000s
Syclone possibly built transmission w/ transfer case
Syclone full rolling red chassis w/ rear disc brakes, new front clip and new grille, complete interior, and comes with 60% cladding.
BUILT MOTOR
SHORTBLOCK
Stock block bored .030 over- $300
TRw L2441 pistons with JE rings-- $450+$125
Upgraded rods- $180
Clevite bearings- $40
Comp 415 Cam--$260
ARP bolts- $30+$65
Lunati lifters-$215
Chromoly pushrods-$100
Edelbrock TC-$70
SFI billet harm. balancer-$225
SFI race flexplate- $95
HV oil pump-$115
I have $2500 in parts alone not including labor
LONGBLOCK
Vortec heads-$125,
Drilled-$150,
5 angle valve job/teflon seats/bronze guides-$225
ARP 3/8 rocker screw in studs-$70
Comp cam 1.6 Rocker-$260
Comp beehive springs-$250
Cometic Head Gaskets-$180
Ferra valves-$70
Lower intake modded for Vortecs-$400
ARP head bolts-$150
Various machine work-$475
I have $4855 in the longblock not including labor. Basically the same as:http://www.sytyperformance.com/inde...facturer_id=0&option=com_virtuemart&Itemid=26
I will take $2000 for the short----$4000 for the long OBO
I can probably ship this in the 48 for less than $150
This combo is easily capable of low-mid 10's w/74gtq and proper tune
ATR headers, ATR down pipe, and Sy/Ty 700R4 Race transmission, let me know i have a price in mind to go with the package deal.
IF ANYONE IS INTERESTED PLEASE CALL ME!
Thanks, Nick
850 642 7433
All parts are located in Destin, Fl.
Last edited:
That IS a ton of stuff. 
