VinPecora
New member
my truck in on the lift and I never got the Install diagrams for the Suspention Techniques Rear Swaybar. My mechanic needs it if anyone could please email it to me at Vincent.Pecora@Morganstanley.com, ASAP!! THANKS
Someone Help me Please!!!
- Thread starter VinPecora
- Start date
KGB Pilot125
New member
did you get the instructions? I have put one on before where is he stuck at? you have to cut the gas tank shield to mount the drivers side point other than that its a stack of washers and rubber pieces.
JustBeachin
Plays well with others
Re: Someone Help me Please!!!
Which one? Sy or Ty? On the Typhoon, it's pretty straight forward, only drilling required.
VinPecora said:
Which one? Sy or Ty? On the Typhoon, it's pretty straight forward, only drilling required.
hideakimura
NipponSyTy
Re: Someone Help me Please!!!
In my case, drilling was not required, used this hole.
Please be noted that my Ty dropped 2' on rear so bushings should be like this...
JustBeachin said:
In my case, drilling was not required, used this hole.
Please be noted that my Ty dropped 2' on rear so bushings should be like this...
VinPecora
New member
yeah it is a typhoon with a one inch drop, he is stuck at the part where the instructions say look at the diagram for ounting the ends! I have no diagram and Sus techniques fucking suck, they gave me the run around and told me 2 times they would send me the diagram and nothing!
Mad Mike
SYCOSIS
Re: Someone Help me Please!!!
Using this method does not allow the bar to be centered under the differential but rather leans towards the front. Does this degrade it's performance?
hideakimura said:JustBeachin said:
In my case, drilling was not required, used this hole.
Please be noted that my Ty dropped 2' on rear so bushings should be like this...
Using this method does not allow the bar to be centered under the differential but rather leans towards the front. Does this degrade it's performance?
