Sy#1524 rebuild/restore

[NCTyphoonKid]

Re: Sy#1524 rebuild/restore

:tup: looks good it'd be nice to try and get some of the nc peeps together sometime for a meet

 

[graham1524]

Re: Sy#1524 rebuild/restore

Here are a couple of logs if anyone could look through them for me and give some feedback.

http://www.mediafire.com/download/729v0wa93g6u4gw/Log2.uni

http://www.mediafire.com/download/663cokv23so8zvr/Log.uni

 

[graham1524]

Re: Sy#1524 rebuild/restore



Does anyone know where this attaches under the dash?

 

[choffert1]

Re: Sy#1524 rebuild/restore

I think the relay attaches to the drivers lower dash panel (the panel with the vent under the steering column)

 

[Adam#0213]

Re: Sy#1524 rebuild/restore

On the pistons what made you decide to go with that brand? Motor looking good so far!

 

[Don W.]

Re: Sy#1524 rebuild/restore

Here are a couple of logs if anyone could look through them for me and give some feedback.

http://www.mediafire.com/download/729v0wa93g6u4gw/Log2.uni

http://www.mediafire.com/download/663cokv23so8zvr/Log.uni

Besides a pile of error codes? Get those cleared and start over.

 

[graham1524]

Re: Sy#1524 rebuild/restore

On the pistons what made you decide to go with that brand? Motor looking good so far!

No particular reason it was mainly what the machine shop preferred to use so I went with them

 

[graham1524]

Re: Sy#1524 rebuild/restore

Besides a pile of error codes? Get those cleared and start over.

What would cause all the data error codes?

 

[Don W.]

Re: Sy#1524 rebuild/restore

What would cause all the data error codes?

Hard for me to say. Clear all codes by removing the ECM fuses. Wait about 15 seconds, reinsert. Start and drive around until warmed up, maybe on the fwy with some throttle for the heck of it. Run a new log and see what you get.

 

[graham1524]

Re: Sy#1524 rebuild/restore

Has anyone else had an issue with the rpm exhaust? Mine fits like shit and won't tighten no matter what I do to it