It seem to me that my ty's tranny is starting to slip in the 2-3 shift. I was wondering if this is a common problem and if there is any way to keep it from getting worse. I know that 700r4 suck because i when through five of them on my 88 gta. Just kind of hoping that someone might have a suggestion
transmission trouble
- Thread starter K
- Start date
B
Blake
Guest
You most likely have burned up your 3-4 clutch pack. It'll drive under normal conditions for a long time. My Ty went with the clutches completely burnt to the metal(metal to metal)for a long time. Just had sloppy 2-3 and 3-4 you couldn't feel at all.
When you do it, look into the 9 clutch stack from Alto, it is the red eagle friction set. Also delete the 3-4 load release springs from the input drum and increase the size of the #44 hole in the separator plate. This stuff is on Jesse's site. Seal the air bleed hole on the input drum and get a larger TV boost valve. The increase in pressure along with the greater surface area of contact from the 9 clutch stack should keep your sloppy 2-3 from coming back.
You don't have to do anything right away as long as you drive smart and not abuse the crap out of it.
Blake
When you do it, look into the 9 clutch stack from Alto, it is the red eagle friction set. Also delete the 3-4 load release springs from the input drum and increase the size of the #44 hole in the separator plate. This stuff is on Jesse's site. Seal the air bleed hole on the input drum and get a larger TV boost valve. The increase in pressure along with the greater surface area of contact from the 9 clutch stack should keep your sloppy 2-3 from coming back.
You don't have to do anything right away as long as you drive smart and not abuse the crap out of it.
Blake
B
Blake
Guest
PS:You may have been playing with the TV adjustment. DON'T PLAY WITH THE TV ADJUSTMENT TO TRY TO CORRECT IT. You will burn the 3-4 to a crisp and bend the metal plates. Eventually you will have no forward mov't.
Blake
Blake
