Trouble code 32
- Thread starter Bichn69
- Start date
syclone1100
RUNNIN AND SELLIN
Re: Trouble code 32
did you replace the gasket on the egr??? Press on the diaphram and then hold your finger over the hole the vac hose conects to if the diaphram stays depressed then its good if not you got a bad egr... Check vac hoses as well to be safe... Then make sure you reset them ECM..
did you replace the gasket on the egr??? Press on the diaphram and then hold your finger over the hole the vac hose conects to if the diaphram stays depressed then its good if not you got a bad egr... Check vac hoses as well to be safe... Then make sure you reset them ECM..
Re: Trouble code 32
I did change the gasket when i replaced the EGR valve.
I went out and checked the vacuum line and i am not getting any vacuum from the EGR solenoid. How do i check to see if it's the solenoid not working or if i'm not getting any juice from the piece that plugs into the solenoid?
Do I reset the ECM by disconnecting the battery?
I did change the gasket when i replaced the EGR valve.
I went out and checked the vacuum line and i am not getting any vacuum from the EGR solenoid. How do i check to see if it's the solenoid not working or if i'm not getting any juice from the piece that plugs into the solenoid?
Do I reset the ECM by disconnecting the battery?
Re: Trouble code 32
Does anyone have an idea on this? the only code i'm getting is 32 and now when i leave a light it falls flat on its face and then surges up to speed. Then if i floor it the turbo bounces all over the place and it falls on its face. Is this just caused by no vacuum to the egr valve? Any help is appreciated...
Does anyone have an idea on this? the only code i'm getting is 32 and now when i leave a light it falls flat on its face and then surges up to speed. Then if i floor it the turbo bounces all over the place and it falls on its face. Is this just caused by no vacuum to the egr valve? Any help is appreciated...
Flyin Ryan
hated cuz he drives fords
Re: Trouble code 32
pull the ecm b fuse from the fuse panel under the dash by the kick panel on the drivers side for about 15 minutes. This will force the ecm to relearn everything plus removes codes that have been set. If the issues been fixed then the code won't come up anymore
pull the ecm b fuse from the fuse panel under the dash by the kick panel on the drivers side for about 15 minutes. This will force the ecm to relearn everything plus removes codes that have been set. If the issues been fixed then the code won't come up anymore