LikeMy6
New member
Looking for advise on my next turbo, right now I'm using a Mitsu TDo6 25G 12cm with a journal bearing. Engine mods are 206 roller 114LS, ported Vortecs with Milodon megaflow stock size valves, Forged 8.5:1 pistons, eagle rods, Billet crank, 4bolt mains, lower 1/3 block fill, built 700r4, stock converter with 2500 stall, 3"dp and exhaust, Eric's chip, meth injection, ARP everything, ported intake and exhaust manifolds, stock IC with ATR heat exchanger and pump, walbro 800+hp turbine fuel pump.
New Turbo will be a precision Ball Bearing, looking at the 6262 figured since it wasn't too much bigger than the current turbo I have it wouldn't alter my combo much but have a better spool up. Currently launching off the foot brake at 20psi and would like just a tad quicker spool up. The truck is my daily driver and I enjoy the tight stock converter and don't have plans on replacing it.
Let me know what you guys think.
TIA
New Turbo will be a precision Ball Bearing, looking at the 6262 figured since it wasn't too much bigger than the current turbo I have it wouldn't alter my combo much but have a better spool up. Currently launching off the foot brake at 20psi and would like just a tad quicker spool up. The truck is my daily driver and I enjoy the tight stock converter and don't have plans on replacing it.
Let me know what you guys think.
TIA