vari rockers? results?

Injected1

Injected1

Member
Re: vari rockers? results?

Just talked to this guy on the phone, and I agree with him on the fact that it probably works pretty good, but $895 for rockers is a bit much. Also a problem I think our fellow syty's would have a problem with is that this motor/gearbox has to be mounted on top the valve cover on each side and 5 holes total have to be drilled in each valve cover. The motor/gearbox is about 7" x 6" x 5". Where you going to put 2 of those in a SYTY?
 
bezerk

bezerk

New member
Re: vari rockers? results?

about the cost. come on.....i mean good set of rockers is 250, a cam is 250, than you need pushrods for 100. that's 600 alone. this is listed for 895. i wouldn't say the priing is bad if it works.
 
turbodig

turbodig

Active member
Re: vari rockers? results?

Kind of a marginal point in our application.... we have a very broad HP and torque curve already.
And, a relatively low max RPM.

I don't see any other data than their one SBC listing.

It's a neat idea, but tough to justify, if you ask me.
 
bezerk

bezerk

New member
Re: vari rockers? results?

turbodig said:
Kind of a marginal point in our application.... we have a very broad HP and torque curve already.
And, a relatively low max RPM.

I don't see any other data than their one SBC listing.

It's a neat idea, but tough to justify, if you ask me.
Click to expand...

i really agree with that thought. if you were going to race it with a loose stall, bigger turboyou would be in the 3k range right away. on let's say 1.6's rockers. but stil it might be as good as swapping to a bigger cam,, and just be happy with this
 
You must log in or register to reply here.
Top