Hey guys....I've been doing alot of maint/tune-up & minor upgrades this summer ( http://www.syty.net/forums/showthread.php?t=59897 ) & one of the upgrades is the 2600 yank tc im putting in w/ the new trans...& basically i've been having some problems w/ the install...The pilot shaft on the tc seems too long compared to my stock tc...Everytime i try installing the trans, it wont fully seat up against the block....any suggestions would help alot...thanks
Yank tc install Q
- Thread starter mickeyj36
- Start date
syclone0209
Member
Re: Yank tc install Q
are you totally sure its seated all the way. sometimes you have to spin it and push and pull and wiggle it for a long time to get it to fully seat. it can be a pain.
are you totally sure its seated all the way. sometimes you have to spin it and push and pull and wiggle it for a long time to get it to fully seat. it can be a pain.
Re: Yank tc install Q
Yup ive done all of that....After i did all that, i tried to just mount the tc to the fly to see if the pilot will seat....and no cigar....i'll post pics in a lil bit of the the yank and the stocky tc to show where i think the problem is.
Yup ive done all of that....After i did all that, i tried to just mount the tc to the fly to see if the pilot will seat....and no cigar....i'll post pics in a lil bit of the the yank and the stocky tc to show where i think the problem is.
91blazins10
Active member
Re: Yank tc install Q
Heres a pic Mike Cambell posts all the time and its a big help, the mounting pads on the tc should measure 1in inward from the bellhousing of the trans.
Heres a pic Mike Cambell posts all the time and its a big help, the mounting pads on the tc should measure 1in inward from the bellhousing of the trans.
Re: Yank tc install Q
Well heres a couple of pics that i hope will help..but im thinking i may have gotten the wrong tc....i ordered it from yank directly and its suppose to be the YANK 2600 Truck Thruster....I ordered it back in 5/20 so i hope its not too late to return it if it is the wrong one..i couldn't find anything about there return policy...pls chime in with any help...thanks
[/IMG]
[/IMG]
[/IMG]
[/IMG]
[/IMG]
Well heres a couple of pics that i hope will help..but im thinking i may have gotten the wrong tc....i ordered it from yank directly and its suppose to be the YANK 2600 Truck Thruster....I ordered it back in 5/20 so i hope its not too late to return it if it is the wrong one..i couldn't find anything about there return policy...pls chime in with any help...thanks
Re: Yank tc install Q
Thanx...im gonna check for that in a lil...i gotta run to home depot real quick
91blazins10 said:Heres a pic Mike Cambell posts all the time and its a big help, the mounting pads on the tc should measure 1in inward from the bellhousing of the trans.
Thanx...im gonna check for that in a lil...i gotta run to home depot real quick