Z06 info (new pics)

ashman

------
Re: Z06 info (new pics)

slight rubbing at full turn. could probably hammer on the lower a-arms and elimate it.
 

ChuckWright

New member
Re: Z06 info (new pics)

I just installed ZO6s on my TY 18X9.5,54mm offset. 1.5 Adapters in the rear. I ran into a problem in the front. The front axels are too long to allow the center caps to be installed. Did you have the same problem? What did you do about it? I sure like the looks of them. Regards
 

ShuggsRR

Donating Member
Re: Z06 info (new pics)

I pulled off my wheels and used a sawzall to cut them down right before the nut.

Then the caps fit fine. Wear safety goggles and be patient.
 

ChuckWright

New member
Re: Z06 info (new pics)

ShuggsRR said:
I pulled off my wheels and used a sawzall to cut them down right before the nut.

Then the caps fit fine. Wear safety goggles and be patient.


Thanx for the help. I didn't want to screw things up. I think I'll run a nut on 1st and hope it will help clean up the threads after I'm through sawing. Thanks again Chuck
 

ChuckWright

New member
Re: Z06 info (new pics)

ShuggsRR said:
I pulled off my wheels and used a sawzall to cut them down right before the nut.

Then the caps fit fine. Wear safety goggles and be patient.

Do you still have the wrecked Ty? I'm looking for a stock radio with the plugs and wire harness. Regards Chuck
 

2fast4u

PUMPING THAT IRON!
Re: Z06 info (new pics)

ChuckWright said:
Do you still have the wrecked Ty? I'm looking for a stock radio with the plugs and wire harness. Regards Chuck

I might be pulling my stock radio out soon. Ill let you know when its out. Or send me a pm later this month if you still need it.
 

kraus

New member
Re: Z06 info (new pics)

18x9.5/18x10.5 combo in Chrome ($599) (bling, bling) plus shipping ($75) was that for all four or for one rim ,reason i ask is the wife's ty has 17 inch zr1's and where looking at putting 17 inch z06's on it....
 
Top