Syclone #0077 on Ebay

93 TY 2185

93 TY 2185

Donating Member
Re: Syclone #0077 on Ebay

Wow...What a mess. My beater truck is looking better and better to me.:D
I hope that's PVC pipe for the roll cage.
 
Last edited:
fauXGT

fauXGT

Brick Pilot
Re: Syclone #0077 on Ebay

Hope the reserve is about a grand. Replaced pass door (no cladding rivets). WTF with the exposed wire. Looks like the entire dash inverted inside-out. No upper intake = no run.
But it is a rare collector.:screwy:
Its a pile.
 
syclone2673

syclone2673

Member
Re: Syclone #0077 on Ebay

What a shame! Only 24k? If thats true, it is a real shame! That interior is a mess, paint is gone, motor toast....... I have to agree with fauXGT, Its a pile.
 
berzerker

berzerker

wookie
Re: Syclone #0077 on Ebay

what a disgrace ! the lower intake looks like a litter box with all the mice droppings , need to get red-green in there and just finish all the repairs with about 20 rolls of duct tape . then drop it out the back of a c130 at 15,000ft . she'll surly hit 180mph and trap at 7.50 et then that cage will come in use .
 
scrape

scrape

New member
Re: Syclone #0077 on Ebay

would make a nice parts truck or v8 swap truck for the track if you could get it for the right price. $1500 or less?:2cents:
 
Smkur50

Smkur50

SYTY Fleet owner
Re: Syclone #0077 on Ebay

resto? More like part out...man with my OCD everything would have to be replaced. :tdown:
 
scrape

scrape

New member
Re: Syclone #0077 on Ebay

Smkur50 said:
resto? More like part out...man with my OCD everything would have to be replaced. :tdown:
Click to expand...
parting out is an option also, but i dont think its quite that far gone it could be salvaged. that interior isnt as bad as it looks, and body is pretty straight except the door cladding. like i said tho, the price would really have to be right. and you should get some meds for that OCD. :lol:
 
warmpancakes

warmpancakes

New member
Re: Syclone #0077 on Ebay

somepolishing compound and a weekend and that body will look 1000 times better, truck will be bit to about 2 grand, if the seller dropped it off at a detail shop and spent 3-400 it would pull 4k
 
Smkur50

Smkur50

SYTY Fleet owner
Re: Syclone #0077 on Ebay

Ok, cladding is ok, dont see the interior being too perfect...pull all body..hope no rust, refinish everything..motor needs redone, new paint, rubber etc..not enough to reuse to be worth it if you do the math.
 
Don W.

Don W.

Stab it and steer it
Re: Syclone #0077 on Ebay

What a piece of >>>> Notice the corrosion on the alum in the engine compartment? That thing has been near salt water IMO. Barely a parts truck. Pull the trans (if it's still original), TCase, maybe the block. Why the roll bar? I'm not sure it's even NHRA legal. Sad.
 
Blazerspeed

Blazerspeed

New member
Re: Syclone #0077 on Ebay

Ha wonder what the reserve is set at, poor thing looks like it lived it's life outside. I wouldn't call it a parts truck just yet, everything will need to be gone over. I would say anything over a 3k asking price is crack pipe territory.

But as always...there is a sucker born every minute. So I'm sure someone would pay out for this rare collectors piece.
 
You must log in or register to reply here.
Top