Recent content by mjaugus

Re: Code59 King of the Hill 11.80@113 Atco,NJ a few years back. Motor went south not to long after and will be starting over next year.

Re: X-Mas presents Got it a little early but

Re: ticking - no knock, just annoying. Check that those Eagle rods aren't bottoming out on the pan.http://www.syty.net/forums/showthread.php?t=73159file:///Users/michaelaugustine/Pictures/iPhoto%20Library/Originals/2009/Dec%2018,%202009/P1010587.JPG

Re: Do I need to be rich? Drivin around is cheap.1/4 mile costs

Re: Chip burning Hey Mike,I'm in south Jersey and was in a similar position with an ultimate 50lb. set up(not a daily driver).After many,many hours of failing to stop knock I tried contacting people to burn a new chip.Dig suggested I go $59 and sent me base 50lb.bin.I searched and read for...

Re: Another 11's thread Linda Vaughn! Ahh! Don't blink.

Re: Crusader8's Dad making some Runs @ Atco<UPDATED> Hey George, Really enjoying the 80E.Let off on that 14. run.I had the shift points around 5400,but it was shifting around 5200.I raised the wot time to 1.0 and felt like I hit a wall at 3900 rpm and let off.Got back to the pits and the...

Re: First Trip at Atco on new build Thanks Ralph, Hope to see you there this season.I saw how conservative you were, early on in the tuning, and i'm following your lead.Pump gas,low boost untill I'm sure of things.I had to get a couple of trips down before I'm working on boats all summer.

Re: 4l80E install. Transfer case does not fit. We loosened up the body mounts and raised it up a couple of inches.Also masaged the lip on the sheet metal above with an air chisel.Still dificult,but doable

Re: looking for a pair of tires 275/40R17 Morgan, Got 4 stock wheels w/tires in Beach Haven.Look at Jim's pictures(locals only)in this forum. If they work for you,I'm sure we could work out some kind of trade down the line.Even if you just want to borrow them.Mike

Re: TP vac reading $59 All is well.Start tp after engine is running and it reads correct!

Re: TP vac reading $59 Will do.Wasn't sure if the problem was related to 59.

Re: TP vac reading Please delete

Vacuum reads low(4.95-5.55Hg)at idle in tunerpro.Guage at map and fpr reads 16Hg.Reset the ecm and TP will read correctly,but only until restart.Checked grounds and ecm connections,replaced 3 bar map.I've messed with every wire there is during the last year,so I figure its something I did.Anyone...

Vacuum reads low(4.95-5.55Hg)at idle in tunerpro.Guage at map and fpr reads 16Hg.Reset the ecm and TP will read correctly