Search results

Putting motor back together and im not 100% on where all the lines went and if they were correct to begin with. The vac resevoir or vac ball has an inline check valve but i think it was backwards when i got the truck, which way should it be in line? Thanks for any help

I need to plumb water lines to the center section of a ball bearing turbo. What are you guys using for a pressurized feed source? Does the block drain hole work since there should be a good amount of cool pressured coolant? Any pics? thanx

All the parts places i call say its no longer made or they try to sell me one for a reg s-15 pickup.

If a pt67 only has a oil line going to it does it mean its a journal bearing turbo?

I have a built motor with 4bolt mains, cryo crank, vortecs, 50# injectors, atr headers and 3" dwnpipe and a 415 cam ready to install. Will the pt61 get me over 500hp on pump gas? of course with a good tune. I have a bult trans w a 2800 lock up convertor. . I was looking at the gt35r but its a...

I currently have atr headers and downpipe with a te-44 turbo. I would like to upgrade to a ball bearing turbo but i dont know if thats possible without changing headers?? what are my options for my set up?

I finished building my motor @ work and threw it on the engine dyno to make sure everything ran good before i put it in the truck. Here are the mods: Ported vortec heads 2.02/1.6, 415 cam, 1.65 rockers, 8.5:1 cr, 31 deg timing, 4 billet main caps w splayed 4 bolt center mains, cryoed crank...

They would be around $250 for the pair. Got a fiberglass guy who wants to make some but he wants to do like 10 sets. Anyone?

Im changing my heads to ported polished vortecs and bigger 1.65 roller rockers. The truck currently has a ultimate chip setup for stock heads and custom cam( basically the 415 cam), 50lb injectors and 3bar map . Do i need to have the chip reflashed or burned or something for the head swap...

Looking to have my crankshaft cryoed and i hav'nt found anyone local near n.y.

I need an oil pan and i was wondering if i could just get a reg 4x4 pan from the junkyard and weld a turbo drain return bung in?

anyone know what the numbers on the firewall of our trucks are for??

i have the stock and aux atr heat exchangers plumbed w bigger pump in the truck. I wanted to replace the heat exchangers with one bigger aluminum unit in front of the radiator. Since this cost will be close to that of an a2a intercooler...... I was wondering if i replaced this w2a system with a...

i have a "te44 pte 63" turbo?. or so im told by the previous owner. Ive searched around and couldnt come up with much info. Does anyone know about this turbo? size? horsepower it will produce? where it spools at? it says precision & .60 on the compressor side and the turbine side all i can see...

Im looking at getting some 18" rims. I'd like to stay the same or lighter than stock wheels Preferably c5/c6 zo6 rims or c5 magnesium vette wheels,I have called several aftermarket wheel companies about the weights and they either dont know or they throw some weight out like 15lbs which we all...

My truck has a knock so im pulling the motor. it curently is .030 over, stock heads w/ mild gasket port match, custom cam w/ comp 415 intake lobe and comp 412 exhaust lobe ( they are identical lobes) atr headers, 3" downpipe, pte 61 turbo, 50#, ultimate chip, 3 bar My question is how much power...