Windedv6
Ty n 10s
Some of you may recall that I pulled my 305ci TT out of my 2wd Ty a couple of months ago to go through it for some possible problems with the original build. This also provided a good opportunity to do some upgrades.
A new LSM billet cam was installed...
242/238 duration
630/626 Lift
116* LSA
New Isky Endurance 9000 Springs were installed...
The new motor assembly was dyno run NA for break in...
452 hp/396 Tq @ 6,000 rpms
This was with a 750 dlouble pumper holley. We wanted to go on to 6,500 and 7,000 rpm but it became to lean to do so. If we had a larger carb we may have been able to see close to 500 hp.
The install went very smooth as all the lines were "AN" and the custom wiring harness was bascisally plug-in. Thanks to Bill Davis my original TT TY builder and fabricator everything went back together like a prefectly fit puzzle.
Empty engine bay...
Engine ready to set in...
In and locked down...
Another upgrade was the two new twins! These are new technology with the billet compressor wheel and the anti-surge cover.
T-4 exhaust housing
69mm p-trim turbine wheel
62mm billet compressor wheel
Anti-surge cover
Motor back in and running...
John
A new LSM billet cam was installed...
242/238 duration
630/626 Lift
116* LSA
New Isky Endurance 9000 Springs were installed...
The new motor assembly was dyno run NA for break in...
452 hp/396 Tq @ 6,000 rpms
This was with a 750 dlouble pumper holley. We wanted to go on to 6,500 and 7,000 rpm but it became to lean to do so. If we had a larger carb we may have been able to see close to 500 hp.
The install went very smooth as all the lines were "AN" and the custom wiring harness was bascisally plug-in. Thanks to Bill Davis my original TT TY builder and fabricator everything went back together like a prefectly fit puzzle.
Empty engine bay...
Engine ready to set in...
In and locked down...
Another upgrade was the two new twins! These are new technology with the billet compressor wheel and the anti-surge cover.
T-4 exhaust housing
69mm p-trim turbine wheel
62mm billet compressor wheel
Anti-surge cover
Motor back in and running...
John
Last edited: