345/30/19's on C6 Z06's w/PICS inside

Rob Pod

Rob Pod

Donating Member
Re: 345/30/19's on C6 Z06's w/PICS inside

Do the rears rub when u do a Boosted Launch??? If so, how bad??
 
F

FirstGensForever

Banned
Re: 345/30/19's on C6 Z06's w/PICS inside

What is the offset or BS on those rear wheels? Looks killer. Ive been thinking about those size tires for my 93 S10 LT1/T56 project, but wasnt sure how well they would fit.
 
Gatman

Gatman

Donating Member
Re: 345/30/19's on C6 Z06's w/PICS inside

I have a question NJSERRANO, you mentioned the 1/4" spacers in the back as well as studs? Did you need to do a wheel stud swap in the rear in order to have enough threads for the lugs to bite with the addition of the spacers?
 
DanenGraham

DanenGraham

Big in the rear
Re: 345/30/19's on C6 Z06's w/PICS inside

Gatman said:
I have a question NJSERRANO, you mentioned the 1/4" spacers in the back as well as studs? Did you need to do a wheel stud swap in the rear in order to have enough threads for the lugs to bite with the addition of the spacers?
Click to expand...


Yes you will want the studs. You can get away with a smaller spacer to have more threads. But then you will run into rubing problems most likely, and you will still have only a few threads holding them on.

Get the studs.
 
Gatman

Gatman

Donating Member
Re: 345/30/19's on C6 Z06's w/PICS inside

Thanks for the info. Btw, to the best of your knowledge will the 2010 -2013 Grand Sport Vette wheels work? I'm not sure if the offset is the same or not. Thx
 
Last edited:
S

Snoman002

New member
Re: 345/30/19's on C6 Z06's w/PICS inside

If you get wheel studs make sure to buy the highest quality you can. 1/4" or similar spacers are known for breaking studs as they create a sheer plane that didn't exist before.

Very nice looking setup BTW.
 
Jakazz75

Jakazz75

New member
Re: 345/30/19's on C6 Z06's w/PICS inside

I did some centennial cup style wheels and installed them on my truck the other day while it is sitting in the shop... I basically copied tire sizes from this thread and used c6 front wheel offset. I'll post some pics once I get the truck back and lowered down a tad.
 
You must log in or register to reply here.
Top