No Go

[devroty]

If anyone can help out it would b much appreciated Ive got a 93 Typhoon.
Sometimes it will start and sometimes it would when it doesnt I can hear the fuel pump running whn i turn the key foward but it will just just crank and crank but wont fire off but then other times it will fire right up. could it be then fuel pump or is a fuel pump is all or none. Any suggstions?
Thanks

 

[gjp]

Re: No Go

engine cold, hot does it matter??

 

[ViciousV6]

Re: No Go

If anyone can help out it would b much appreciated Ive got a 93 Typhoon.
Sometimes it will start and sometimes it would when it doesnt I can hear the fuel pump running whn i turn the key foward but it will just just crank and crank but wont fire off but then other times it will fire right up. could it be then fuel pump or is a fuel pump is all or none. Any suggstions?
Thanks

Need 2 thing fuel press Gauge, and friend to help you.

Turn key on and what fuel press gauge and turn key off see if it hold pressure. Then go to gas filler door open up and have them turn key on, turn key off and everytime its on the pump should run for few second then shut off until started.

Hope this helps.
Ralph

 

[devroty]

Re: No Go

When its cold, then last time it wouldnt start I let it sit for 2 days and then went back and it fired right off

 

[devroty]

Re: No Go

ill give it a try
thanks

 

[supersports10]

Re: No Go

When its cold, then last time it wouldnt start I let it sit for 2 days and then went back and it fired right off

ignition module in the bottom of the distributor.

no doubt that is it. $35.00 at the parts store, 30 min install.

i keep an extra one in the truck at all times. plus a 1/4 drive ratchet & 7 mm socket

hope this helps.:myclone:

 

[devroty]

Re: No Go

ignition module in the bottom of the distributor.

no doubt that is it. $35.00 at the parts store, 30 min install.

i keep an extra one in the truck at all times. plus a 1/4 drive ratchet & 7 mm socket

hope this helps.:myclone:

I ended doing new cap and rotor, ignition module that didnt fix it so I put in a new coil and coil wire and that solved the problem
Thanks

 

[supersports10]

Re: No Go

I ended doing new cap and rotor, ignition module that didnt fix it so I put in a new coil and coil wire and that solved the problem
Thanks

ok i stand corrected!!! but at least i was close it was ignition related.

most likely it was the coil wire. i have never seen a stock coil go bad yet.

 

[devroty]

Re: No Go

either way it was stuff that needed replaced it was all in pretty poor shape
thanks