What did you do to your SY/TY today?
- Thread starter SloGN
- Start date
- Status
92Typhoon1110
Rollin The Sy.......
Re: What did you do to your SY/TY today?
You can fix those wires with a little duck tape. Lol just kidding.
You can fix those wires with a little duck tape. Lol just kidding.
Jamerjoe
Member
Re: What did you do to your SY/TY today?
Nice. Luckly I had spare wires laying around. :tup:
Nice. Luckly I had spare wires laying around. :tup:
JSM
Active member
Re: What did you do to your SY/TY today?
4 possible reasons, i suspect the last one though
clearances setup wrong
maincap walk
detonation
lack of oil, starvation (been here done it 3 times)
Of course could be a combination of all of them, but I HIGHLY suggest an accusump for guys going fast. $300 or so to setup is a lot cheaper than new motors. Went through 2 sets of mains, crank work, bearings, etc. Installed an accusump and problem is gone last time I had motor apart it looked pure sexy inside.
4 possible reasons, i suspect the last one though
clearances setup wrong
maincap walk
detonation
lack of oil, starvation (been here done it 3 times)
Of course could be a combination of all of them, but I HIGHLY suggest an accusump for guys going fast. $300 or so to setup is a lot cheaper than new motors. Went through 2 sets of mains, crank work, bearings, etc. Installed an accusump and problem is gone last time I had motor apart it looked pure sexy inside.
Throws
Active member
Re: What did you do to your SY/TY today?
Cleaned up the exterior of "Mable". Clayed the exterior... *damn*.... it was so fkking dirty. Then I did a scratch and swirl remover, during this I had to wash the pad out after each section. SERIOUSLY... what did they previously clean the car with... dirt? Then a nano-polish, and finally a good waxing.
Clean... It's how I like it.
-P
Cleaned up the exterior of "Mable". Clayed the exterior... *damn*.... it was so fkking dirty. Then I did a scratch and swirl remover, during this I had to wash the pad out after each section. SERIOUSLY... what did they previously clean the car with... dirt? Then a nano-polish, and finally a good waxing.
Clean... It's how I like it.
-P
aasltmike
Active member
Re: What did you do to your SY/TY today?
Installed the hood prop rod elimination kit I got awhile back. This thing installed with no issues and looks great! I went with the grip-serts on the hood so that I could easily take the top brackets on and off, if needed. :tup:
Installed the hood prop rod elimination kit I got awhile back. This thing installed with no issues and looks great! I went with the grip-serts on the hood so that I could easily take the top brackets on and off, if needed. :tup:
Throws
Active member
TNPhoon
1of28
Re: What did you do to your SY/TY today?
This looks too familiar...
Last night my woman asked if the truck was broke again because I hadn't been driving it...No...It doesn't have any AC and it's been hot and humid as shit out. So today I drove it for the simple fact that I wanted her to know it wasn't broken.
So then also this salesman at work is f*cking cursed....Last week he sold a car to a new customer...next day, the customers house burnt down...then last night he was supposed to have a customer coming in that called and said he and his sister were just in a car wreck...the sister died this morning...ANOTHER one of his customers that he sold a 2nd unit to last week, their daughter was injured in that stage collapse in Indy last weekend.
So I tell him today he's cursed and to stay away from me. Told him don't touch me, don't look at my truck, don't do anything because something bad will happen. We're walking out after locking up and the bastard slaps me on the shoulder and says "See ya tomorrow!". 45 seconds later as I am pulling out onto Murfreesboro Road, the truck dies.
:steamer:
This looks too familiar...
Last night my woman asked if the truck was broke again because I hadn't been driving it...No...It doesn't have any AC and it's been hot and humid as shit out. So today I drove it for the simple fact that I wanted her to know it wasn't broken.
So then also this salesman at work is f*cking cursed....Last week he sold a car to a new customer...next day, the customers house burnt down...then last night he was supposed to have a customer coming in that called and said he and his sister were just in a car wreck...the sister died this morning...ANOTHER one of his customers that he sold a 2nd unit to last week, their daughter was injured in that stage collapse in Indy last weekend.
So I tell him today he's cursed and to stay away from me. Told him don't touch me, don't look at my truck, don't do anything because something bad will happen. We're walking out after locking up and the bastard slaps me on the shoulder and says "See ya tomorrow!". 45 seconds later as I am pulling out onto Murfreesboro Road, the truck dies.
:steamer:
Re: What did you do to your SY/TY today?
Connected the downpipe to the exhaust, had to cut it to install the turbo a few months back (or I should say berzerker had to cut it, he did all the work installing my turbo :cheers: ). Also relocated my wideband o2 bung and rewired the gauge to try and fix its sporadic readings, didn't work, think I need a new sensor.
Connected the downpipe to the exhaust, had to cut it to install the turbo a few months back (or I should say berzerker had to cut it, he did all the work installing my turbo :cheers: ). Also relocated my wideband o2 bung and rewired the gauge to try and fix its sporadic readings, didn't work, think I need a new sensor.
Aeroking
e.i.
Re: What did you do to your SY/TY today?
lol, i change mine every summer (3k miles). I just removed it and bypassed this summer.
lol, i change mine every summer (3k miles). I just removed it and bypassed this summer.
jeepruby04
New member
- Status