Recent content by Bear Dog

I will be glad to fax some information about pinion angles and how to measure them if anybody needs it. Eric

My lower IC radiator is toast and I need to know what everyone is using for a replacement. Is there a good aftermarket unit that will work without major modifications? I tried the search but couldn't find anything. Eric

A lot of you have been emailing me asking about bigger sway bars that I talked about being in the works a LONG time ago. First off, sorry it's taken so long to get these going. I have lots of excuses, all which don't matter, but here are some of them: Our controller was caught stealing 100's of...

As Product Manager for both Belltech and Suspension Techniques and holding both sets of rear sway bar instructions in my hand I can tell you the the rear sway bar is designed to be mounted UNDER the rear axle not on top of it. If anyone has a set of instructions with our logo on it that states...

Sorry for taking so long in responding to your help. The Ty would not start at all on Friday so I took the day off to work on it. I bypassed the Racetronix unit and plugged in to the factory wiring and it started right up. It runs and starts just fine. I know the fuse is good so now I will check...

Anybody out there? Maybe a bad ground? Eric

My Ty has been hard to start for the last week. It seems to not be getting FP everytime I turn the key on. Two days ago the fuse blew while I was passing a truck. I replaced the fuse and also replaced the relay that sends FP when you first turn the key on. Everything seemed normal for one day...

I will buy a dog tag. Eric

Last Friday I cruised from L.A. to Vegas in Ty #2350 following the #1 Marlboro Sy to the Primedia Vegas Nationals Truck show. I just wanted to give Lou a special thank you for bringing out the Marlboro truck and putting some miles on it. It drew a lot of attention at the show. That is one...

Thanks for the info! Eric

Can somebody please give me the extended and collapsed lengths on Sy/Ty factory shocks? Thanks, Eric

Merk, I sent you a private email. Hopefully we will have the new front bar 1-3/8 " and the rear bar (prototype being tested is 1-1/4") in production in the next couple of weeks. Sorry this is taking so long. Part of the problem is we are right in the middle of moving our R&D facilities into a...

Since they are next to the couch put a piece of round glass on top and you have some very cool end tables. They will be very cool on your truck. Eric :D

Make sure you use extruded aluminum blocks and not the cast aluminum type. The cast ones break easiser. Eric

Merk, Unless you are rubber man I would suggest adding about 6" of length to the fuel lines after you drop the tank. The hardest part of the job was trying to reconnect the lines. I installed the racetronix kit on my Ty and it is very simple, only took about 5 min. to install...