Recent content by whooped

Re: Vote on a cam bullet racing cams hands down

Re: rear stabilizer bar with stock suspension longer endlinks?

Re: should I buy this motor? it's $800, i'd buy it just for the parts on it... they could easily be cleaned and resold... there's fools out there (like myself) that would pay for some separated parts on it.

Re: rear axle reluctor rings for 4wal systems Dave I am truly grateful for the info. looks like i'm still going to have to get them custom water jetted to work

Re: rear axle reluctor rings for 4wal systems Seems they may be the same as what's pressed onto the front rotors. I'll have to double check

does anyone have them on their stock used axles that they could take some measurements for me? i need more information and nobody sells them that i know of. any help is appreciated, also if you're willing to sell them i'm willing to purchase. thanks in advance

Re: Rear reluctor ring tooth count 40 views... nothin?

Anybody know the tooth count of the rear abs reluctors that are pressed onto the axle? Also does anybody know where to buy them skinks?

Re: Racetronix Fuel Pump Harness Mini HowTo it's not terrible. instead of removing the bumper i took off the rear driver's tire and substituted longer bolts for the fuel tank lower straps one at a time. the longer bolts will give you more room to work as the tank will "hang" lower while you...

Re: unhappy typhoon N/A 4.3 did this to me... check the harmonic balancer. cracks in the rubber indicate that it's time for a new one.

Re: Probe pistons. $329? from who?

Re: 875-12 Comp Cams vs Stock/850 Lifters - Disassembled so you're saying that with valve lift of .498/.498 on a 1.5 rocker that low travel lifters, such as the CC875s need to be used but only in conjunction with full roller rockers due to their low volume of oil transfer?

Re: just want to clear things up http://www.summitracing.com/parts/TFS-21400002-16/ like these?

Re: just want to clear things up so by using comp 875s the tick tick tick will be guaranteed to not show up if the valvetrain is set up/ adjusted correctly?

lots of posts about the tick tick tick sounds... none seem to be conclusive. I'm asking if anyone has found a definitive answer to the ticking noise coming from the valvetrain? i've seen a post about comp magnum hydraulic roller lifters. but what is the difference between these...