Search results

  1. Anthony

    e-85 fuel and it's benifits.

    Re: e-85 fuel and it's benifits. Are you running 100% E-85 now?
  2. Anthony

    MN/ND/SD SyTy/GN race gathering

    Re: MN/ND/SD SyTy/GN race gathering Burnin' oil and breakin' hearts is what the PIG's all about. Sunni's decided that towing the Ty would be best. We'll head up Friday morning and head home Sunday. Sunni has chosen the Country Inn and Suites as our place of rest. You better be ready to...
  3. Anthony

    MN/ND/SD SyTy/GN race gathering

    Re: MN/ND/SD SyTy/GN race gathering Hey Dig, are they strict at all with the helmet ratings? My helmet is DOT approved, but has no Snell or SFI rating. LIQRPIG's finally getting an alignment, so that should shave a solid .05 off my 1/4 time. We haven't decided if we're trailering it or...
  4. Anthony

    MN/ND/SD SyTy/GN race gathering

    Re: MN/ND/SD SyTy/GN race gathering As long as the LIQRPIG holds together, we'll race it. This weather has been horrible for tuning. We'll likely be there either way, though. Is Ralph gonna be ready for the showdown?:) Did you shoot an e-mail to Mark Larson?
  5. Anthony

    Bad boost problems. HELP!

    Re: Bad boost problems. HELP! I had a very large leak in the underside of my IC to TB connection that was limiting my boost. It would blow open over 5 psi just enough to bleed off boost. The bike tube test made the leak pretty obvious.
  6. Anthony

    Taylor Plug wires... which goes where?

    Re: Taylor Plug wires... which goes where? Go to the MSD website http://msdignition.com/wire_sets.htm#chevy and they have the lengths for each cylinder's plug wire and it's boot.
  7. Anthony

    Valve Cover Gasket Q

    Re: Valve Cover Gasket Q Napa sells "tuff-cork" valve cover gaskets that will fit without having to be stretched and glued with aftermarket valve covers. The napa # is VS50024TC
  8. Anthony

    No Fuel pressure 139 mile truck

    Re: No Fuel pressure 139 mile truck If the fuel pump relay is not energized, the truck will start when there is enough oil pressure built up via a bypass circuit. Swap the AC and FP relays to see if that's it. If not, check for power on the gray/white wire that the ecm uses to energize the...
  9. Anthony

    Compression Numbers

    With a cold engine and throttle open, my 110K mile Ty had right around 105 compression. It had just ran a 13.4 @ 99.5 before I checked the compression.
  10. Anthony

    Question for those with Brodix heads.

    I had my manifolds coated with JetHot 2000, which did zilch for heat control. A better manifold coating may indeed help. What lasted the longest for me was the MSD race boots with the ultra-expensive Moroso plug booties. I got about 200 miles out of those before half of them burned through...
  11. Anthony

    Removing eeprom from memcal.

    Re: Removing eeprom from memcal. If you don't care about the stock chip, you can also snip its pins to get it out, and then take a tweezers and pull out what's left of the pins after you heat them a bit. Just thought I'd throw that out there for ya :D Anthony
  12. Anthony

    Pontiac heads?

    Just to get this info out there, if anyone's planning on using the straight-plug Lil' Brodies with stock manifolds, the head on the driver's side needs to have the shoulder trimmed back to allow the manifold to sit flat against the head. The spark plugs do sit closer to the manifold as well...
  13. Anthony

    fab-ing a2a on stock turbo Ty..Any other opinions?

    It is also extremely easy to make a bracket that will allow you to use the stock wastegate actuator after the turbo has been clocked. That is IF you really want to use the stock wastegate... Anthony
  14. Anthony

    Minnesota Pics

    Congrats on getting that many trucks together! Can you put owner's names to the trucks? Anthony
  15. Anthony

    A day at the track with Dig.

    Re: A day at the track with Dig. Nice times, Paul. How much more are you hoping to get out of it, e.t. wise? Kind of makes me wish I had gone that route with my 110k mile Ty... But I guess someone needs to put Buster in his place :lol: Hopefully Sunni, little Magnus, and myself will be...
  16. Anthony

    non ac heater box firewall cover availability

    I just got one from gmpartsdirect about a month ago. If the website brings up the correct part # and description and lets you order it, I'm willing to bet it's still available. Don't forget to order a new gasket as well if you go that route. Anthony
  17. Anthony

    non ac heater box firewall cover availability

    You could always get one from gmpartsdirect.com. I know it is available through them. Anthony
  18. Anthony

    Flow nr?

    My -8s, done by a local shop, flowed 267/210 @ .500 lift and 282/223 @ .600 lift. They weren't flowed at .700 lift. Those #s are with 2.05/1.60 valves. Anthony
  19. Anthony

    ram charger boost controller

    Buster was using it for a little while. PM him and I'm sure he'll give you some help. Anthony
  20. Anthony

    Slide a links

    How 'bout an update :) I'd say they worked pretty well considering the 1.6 60ft in 40 degree weather at night on a less-than-optimally-prepared track. Plus, they look so darn sexy. How much were those bad boys? A
Top